KICKERCK4 4AWG Complete Amplifier Kit

This is a nice starter kit. All the wiring is oxygen free copper (OFC) instead of the copper coated aluminum (CCA) that is in most sets. If you don't understand the difference look on YouTube for some examples, they can show how a system can lose power and get much hotter using CCA instead of OFC. I used it to power both my new amps (split ground and power into 2 8-gauges). There is good shielding on the RCA's and the speaker wires have nice thick insulation without being hard to route. The section of the battery cable that sits in your engine compartment being black is a nice touch for a clean, factory looking install. The loom was just long enough to protect a little ways past where I went through the firewall; I didn't have any good spots on the same side as the battery and had to go on the opposite side of the engine. The fuseholder can be secured a couple different ways and cover is nice and secure. Overall you might spend more, but it's worth it for something you will enjoy in the years to come

The quality of the wire is very nice and better than the cheaper budget brands. The wires are so long that I had a lot of extra. Longer is better than too short! The only bad thing is that the fuse cover comes off easily, and it would be recommended to zip tie it shut!

After countless failed searches, this gem came up and I jumped at the offer. Best deal I've come across. Best buy charged my $149.99 for a wire set when they installed my stereo. It wasn't even OFC!!! The power wire was so easy to run because of its flexibility. I used the remote on wire as speaker wire since I used a LOC. The RCA cables are high quality and super flexible. Overall, very happy I found this. My amp and sub couldn't be happier.

Nice 4 gauge wire kit. Wish the power wire was red or black but the ground is nice with the end already on it. Speaker wire casing is a little tough to split evenly without exposing wire. I prefer a smaller fuse holder than this bulky rectangle and be careful with fuse sizing because 100 might be too big for your amp and will not blow before the amp does.

Got this for a kicker amp that runs a 12 inch kicker subwoofer. Works great and comes with washers and a self tapping screw for the ground wire. The power and ground wire are a bit thick so I had to buy a little metal attachment at Home Depot so that it fit in the smaller amp slot. But installed pretty quick and works well.

I wanted copper wire which is why I bought this.I probably could've gotten an 8 gauge kit instead, 4 gauge is a little overkill for my needs. An 8 gauge wire would've been easier to route and fit under the carpet.I wanted my amp to get plenty of voltage, why I bought this.Voltage drop hurts the watt output of the amp, and I wanted my amp to perform at it's best.Worth the extra money IMO buying a premium copper wire kit like this.

The power cables have very high strand counts making them very flexible. Wire insulation has printed on it, 1862 strands silver tinned OFC copper. There is weaved loom over sections that will be under the hood. Make sure you have good heat shrink on hand in case you want to shorten those sections of the cable. There was plenty of cable to run where it was needed. RCA cables are long. Comes with the remote trigger wire as well. Terminals are installed on one end of power and ground wires.

I am impressed by quality of the wrapping. Has everything you need and the fuse and block are amazing. Kicker has been said to have good cables and I have been proven. Don’t like kicker? Go with Rockford fosgate, good cables too just more expensive but these id say are better. At least on the outside. Rockford dosage claims to have better wires. Regardless these cables are amazing