3M 08998 Rust Fighter-I Application Wand

good item works well

Works but fluid needs to be fairly thin. Atomizes well. Not very flexable.

Jim (Danasaur's husband) This item threads right on to Astro Pneumatic 4538 Economy Air Undercoat Gun and does a good job. Sprays 360 or 180 degrees. Mine came in a long box and wasn't kinked at all. Nice product, but perhaps a bit overpriced. But.... if you need to spray into long or deep areas, it works great.

this took a long time to arrive so I took some clear tubing I had and melted end with a torch, flattened end and used a small nail to pierce the tube at angles and worked great. If this had arrived sooner I would have used it.Ok did a 2nd car and tried this vs my home made tubing sprayer. This thing kinked, would not bend and when it kinked caused the spray gun to blow product onto the side of the car. glad I used plastic sheeting to cover the car and taped it to the car at lower edges.

Item was broken, stored in garage until weekend that I needed it, discovered the tip/nozzle was broken off. Too late now, had to make do and improvise on the weekend, as time was limited. Would not purchase from this retailer again!

I attached this to the Astro 4538 gun I purchased here. I used it to apply fluid film to undercoat my vehicle. The outside temp was around 55 degrees. I used up to 100psi and couldn't get it to spray right. I think the fluid film was to thick so I'm going to heat it up and try again.

This application wand works fairly well. It has a 360 degree pattern or you can adjust it to spray 180 degrees. The only issue I had was that it kinked pretty easily. Once it kinked, it continued to kink in the same spot. A kink is no big deal except when the product sprays out of the vent holes in the gun and onto your mask and goggles. I recommend this application wand as long as you do not need to make sharp bends. The problem is, for applying Rust fighter into the places it needs to go, you must bend the hose...

This will do the job. It is made of a hard plastic... I kind of dreamed it would be metal. But I'm over that. The price was right and I only plan to use it on one car project. Other reviewers are correct,it does show up in a coil.. since it's shipped that way. And convincing it to get on the straight and narrow is some work. We live in a plastic world.. I need to get use to that. I would recommend it to a friend.Amazon once again.. made this transaction easier than fighting traffic and heading to several stores to try and locate it. If it anyone even carried it.