2PCs Truck LED Running Board Lights Sequential Amber Side Marker Light 70 Inch Emergency Extended Crew Cab 216 LEDs Waterproof Flexible Turn Signal Light Bar for Pickup Trucks Car (70in)

Outstanding! These work great, easy install and are bright. I have installed on two previous trucks and will use this brand in the future. The sequential flash that moves left to right is great to grab attention. When pulling my trailer it makes for a great illuminator to cars beside me, showing I am changing lanes. The white light for running board or under truck lighting is perfect.

These lights are great however I don't really like the way they flicker so much when turning from amber running lights to white courtesy lights when you open the door. Reason why it does this is because the inside lights turn on gradually and off gradually therefore full power to the led lights aren't there which causes the flickering. I have no way of switching the settings to instant on and instant off fir the courtesy lights. Does anyone know how to get around this, wire the white wire to a different place that when the door opens, it gets full power right away??

The adhesive started to wear off after about a year. But it fit good bright lights. But really bummed it didn’t hold up longer. Seemed to have gotten dimmer over time.

Nice very bright Led lights! I installed them and they just look great! Thank you!

This actually took me a long time to plan and install on my 4th Gen Ram 1500. Mostly because I could not locate the wiring for my courtesy lights when i went to open my door. I wanted to write this review to help others decide if they should take on this project. Now for the parking and turn signal lights it's pretty easy to figure out which is which. After you unplug your light connector, put a voltmeter lead and see which goes to 12v when you have the parking lights on or the turn signals on. That will give you an indication which wire to splice into or solder into when you wire them in. As for the hard part, I spent a long time looking for the courtesy light to wire them into when you splice the white LED lights. I looked in the Haynes manual which has the electrical wiring for all the interior/exterior lights. I had spent most of the time looking for a color code on a huge harness that had 100 wires for that particular color code. Most trucks have a tiny courtesy light bulb near the engine release lever or a light bulb in the door trim that turns on when you open the door. My truck had none of that, so after tons of research I finally decided to trace the dome light wiring. Voila! Which i found the color code i was looking for! So I just tapped into the dome light wire to the "door assist" white LEDS you see in the video. Depending on your skill level, I'm more of a DIY'er or hobbyist, so I'm definitely not a professional, it will take probably a weekend or a whole day, removing the headlights, splicing wires, running wires together, jumping the wires from the cabin to the engine bay, and putting everything back together. It's definitely worth it, my truck gets a lot of attention, and the added courtesy lights makes it so much easier to get cargo out in the dark. I also like when I'm on the freeway, a lot of cars notice me before I notice them. I've had this light on for almost 6 months I still get a kick whenever I open my door or when I drive at night, it's definitely worth it if you want to invest the time to make your truck more custom and more functional! EDIT: There was a reviewer that said the 3M tape was no good. I cleaned the area that I stuck onto with alcohol a few times and it is very strong! EDIT 11/26/23: Many users complained the amber parking lamps were too bright sometimes. I have managed to wire in a SPST Nilight rocker switch. I just connected the power side of (switch) to the parking lamp circuit/wire, the center prong of the switch to the RED wire of the LED ( 12V+ parking lights), and the top copper prong of the switch is to the ground of the vehicle or NEG (-) of the battery. I have managed to turn off the bright amber parking lights while driving. So it's definitely a plus to go stealth mode sometimes!

They looked really good at first. Seamed like good quality. Wired them through the truck to the running lights and door lights, used all heat shrink connectors and weather proof wiring… After about 3 months when it would rain the left strip would start flashing, the white light would come on also causing my dome lights to come on randomly. Now it stopped working completely. About another 3 weeks the right side did the same thing… checked all my wiring and found out water was getting into the strip itself shoring out the little board in there making it flash and do all kinds of stuff…. I guess all I can say is if your gonna buy it leave slack in the wires so you can replace it every 3/4 months.

This will be my 2st set. I loved the first set till one side stopped working. They didn't work right, all of the sudden. They lasted about 5 months. I hope this set last longer. I had them wired into the wires to my Trailer plug. I think that is the best way to go.

Excellent product, installs easily and works great. I am very satisfied with the brightness, quality and wire length. This is a home run!

Sticks to truck great but some lights flicker and are burnt out as soon as turned on.

I’ve got a strip with different wire that what is in the instructions manual. White and blue are the same. Turning signal is not working . Only marker light and white light are working. It is not what they have written.