Universal Microphone Shock Mount, Mic Clip Holder for 47-53mm Mics, Anti-Vibration, High Isolation

Holds my Behringer C-1 microphone snugly. It's got a good build quality, and keeps the microphone held under good, strong tension. It's all black, and sleek with a smooth finish. It absorbs vibrations like a champ, and is fantastic value for the money.I'd definitely buy this again.

A must have if you have a rode NT mic and you’re tired of the one that they included because the shock arm is just so heavy this one pretty much almost a quarter of the weight and it makes it so that your mic arm doesn’t start sinking down. Does the job pretty well too highly recommend that you also buy a pot filter that can attach that at that point you’re pretty much set.

I ordered a couple of this mounts that I've been using mostly on the two newest versions of the Røde NT1: the 5th Gen and the Signature Series (both mics have the same dimensions). These shock mounts hold reliably, and their compact size and quick attachment make them fantastic alternatives to the bulkier, more obtrusive mounts that come with the Rødes. I still have use for the OEM mounts, but only in situations where I need the pop filters that come attached. Otherwise, it's these 3rd party mounts ftw.For these NT1's, I do have to make sure to set the shock mount's grip closer to the head of the mics than the bottom; the mics' tapered circumference means that the mount is more likely to slip if set too low. Otherwise, setting it higher makes the mics very secure.If you need to use the NT1 with a pop filter, I'd say that the included shock mount is the way to go. For a simpler setup, though, I'm happier with these alternatives!

I run an RE-20 on a rigid desk mounted El Gato boom arm, the factory hard mount transferred quite a bit of desk vibration into the mic. This shock mount attenuates it a good bit and it's a lot lower profile than the EV mount that is truly meant to be suspended in the air. I prefer having the mic mostly out of frame and below my face for business use.It is not a miracle cure but it helps and the price is right. Build is solid on it as well.

Works for the Electro-Voice RE20. :)

Superó mis expectativas, producto excelente. Fuerte, apretado, sensación de calidad al tacto. Va full con el zoom mic

This is 42-45mm! Again!! I am tired of buying false advertized larger mounts and getting this junk. Over and over again!!Sellers! It is likely not your fault but some stupid leging manufacturers who mislabel their products. So MEASURE the openings before putting your batch on sale!!

I am running the Elgato wave low profile setup. It is a spectacular combination. The mic fits right in and stays on the arm. The knuckle is strong and the mic does not droop down. I did not even have to adjust extra pressure to the gas arm to hold the weight of the mic and the mic and the shock mount. I needed to have the room to be able to type and move around the desk without desk and vibration noise. I was going to go with the Electro Voice shock mount but it is over 100 and so large that it would impact the space when I turn the arm around while not in use.I highly recommend this shock mount because it fits easily and absorbs all the vibrations from the desk.