3 Pieces Maple Leaf Silicone Molds Pot Leaves Shaped Keychain Molds Hollow Leaf Shaped Earring Chocolate Candy Clay and 10 Key Rings with Chain for DIY Baking Crafting Decor

Both of the weed leaf keychain molds were not nice and clear. They have what looks like water drips and drops built into the mold and bit nice and shiny, which if course come out in the resin. They are also quite thin and flimsy. Very disappointed as I really needed them. I had bought 1 from Etsy prior and it was sturdy, clear and shiny.

These moulds come ready to use. They have a good uniform thickness. The only complaint I have is that the small keychains come out too thick to get the lock ring in without modifying it.

This mold is thin in the middle and thicker towards the edges which makes all the resin sink in.

Made plenty of key chains out of these highly recommend

I do like all of it only thing is when removing from mold I have to sand down the edges and points as they are very sharp. But still give it a 10/10

I really like the little double mold. The larger 2 on the other hand. They were very thin in the middle, and thick at the top where the keyring hole is. Everything flows to the middle. Can't fill it all the way because the stem at the bottom is cut slopping in so if you fill it till the keyring part is full, the stem is flowed over.

Love them. One of the leaves has a few small spots after unmolding but nothing I can’t cover with a little more resin.

11/26 UPDATE - After demoldijg and inspecting the smaller mold pieces, I've realized all these molds are useless. All of them, big and small, are damaged and leave marks on the resin pieces. Honestly, skip these. - END UPDATE Very cute molds! Sadly though, the larger leaf molds had some sort of film on them. I tried washing it off, even tried cleaning it with alcohol and it never came off. I did test the molds to see if the film-like imprint would come off and it did. They have this foggy look to them on one side. I'm letting them cure fully before attempting to fix the piece by cleaning it or sanding and doing a thin top layer. Only 3 stars because I technically only have the smaller molds to work with now.