KICKERDSC350 3.5-Inch (89mm) Coaxial Speakers, 4-Ohm (Pair)

Speakers sound great, at least better than stock. installed as dash speakers on a 2023 forester with HKarman sound system. simple install, fits like stock. there is no plug adapter available, I had to cut my wires.

I installed them on my 2024 RAV4 XLE to replace the stock dash tweeters, used a RED WOLF Car Front Dash Tweeter Speaker Wiring Harness to hook up to the existing connection, didnt need to flip or reverse polarities, worked right out of the box.I did adjust the EQ since the treble was too much and the mids needed a boost which I changed with the settings on the center display.Just look how huge the speaker looks in comparison to the OEM one

Way louder and clear

Always disliked imbalanced audio systems in cars so soon after I installed a 10" in my '18 Rav4, I decided to replace some of the stock speakers to try to keep up with the new volume. I've had kicker subs going way back and always appreciated the quality so I decided to give their speakers a try.These 3.5"s are perfect for my application. They fit in the stock spots on the dash in my 2018 Rav4. I did find out you need a wiring harness set of connects or you can cut the 4 wires, link both similar color wires together and run them to each terminal with spade connectors.They are LOUD. Very much capable of hitting the high frequencies that ensure the voices, high hats, chimes and other high frequency parts of songs not get lost in the bass. I would agree with the reviews that they can be ear piercing so if you like to listen to music loud, make sure you only purchase these if you have a equalizer auxiliary or built into your head unit so you can adjust the frequencies to avoid this issue. That being said, i couldn't recommend them enough. Superb clarity. I listen to them pretty loud on my daily commute and in the few months I've had them, I've had zero issues with clipping.

So I installed these tweeters in my 2017 jeep wrangler unlimited, they fit perfectly in my jeep’s soundbar, they fit amazingly in the sound bar, although I cannot say the same for the front dashboard. The tweeters in the dashboard are different from the OEM speakers and appear to not fit properly, this leaves to a little gap in between the dashboard and the speaker cover. Although there is a slight aesthetic difference I still prefer these over the OEM speakers, as they perform extremely well and the sound quality is much clearer. If you are willing to ignore the slight distortion in the cover, I would greatly recommend!

These speakers are fantastic. I just put them in my vw golf mk2 and with just the front speakers and a 10inch sub I get great sound and clarity. I can crank it and the sub doesn't overpower these 3.5 speakers. Now, they are aimed at the windshield so there is mechanical amplification there but that's just a bonus. I'd recommend these to anyone who is NOT wanting to wire in a four or five channel amp. The reason for that is they're low watt rms of 20. You could buy the kicker cs series if you're looking for amplification but these are perfect for stock replacement. Amazing performance would sum up my review.

Fit Toyota Camry 2012 perfectly. Direct replacement for the dash speakers. I also purchased a wire harness which plugged in to the existing vehicle wiring. This install took less than 10 minutes. Very easy and straight forward. No drilling, modifications, or additional hardware was needed.

I got these based on the cost and some of the better reviews. I needed to replace the terrible 2.5” full range speakers in my Subaru Legacy with Harman Kardon system. These fit with some massaging of the dash holes. However, (as you would expect) the factory amp was tuned for the awful speakers and made these sound terrible. Not their fault, so the amp was replaced so that I could tune the sound.Now for the proper review. These are very efficient - much louder than the 2 ohm drivers they replaced. They are also very loud in the mid to high range. The tweeter is very loud and not well balanced with the woofer. Piercingly loud. I tried to EQ them down, but the EQ setting was like falling off a cliff above 3kHz. So, I padded the tweeter down by cutting the tweeter wire and inserting a 2.7 ohm resistor in series. This made them far more livable. Still a bit loud in the 3-5kHz range, but able to be EQ’d now.If I had to do it again, I’d dig deeper than the reviews and pick something more focused on sound quality. Something with a soft dome tweeter and a better crossover network.