uxcellBreuer Chair Foot Floor Glides Single Prong U-Shape Caps 22mm 12Pcs

They work well, replacing the old and cracked ones on my deck chairs

Fits chairs perfectly and inner tap fits into existing holes and keeps glides in place. No floor marking.

My patio chairs have feet like the one pictured, and they were worn down to the head of the screw, which was scratching the concrete. I searched everywhere for the replacement rubber/plastic feet with no luck. I saw another review where someone used these in place of the kind I had. So I bought enough to do my three chairs. They’re easy to install, I just unscrewed the old ones, drilled out the holes to 11/64”, and popped them on. That size hole gives a nice, snug fit. Time will tell how long they’ll last.

Nipples fit my old 70's tube chairs; I greased them up good with GE Silicone Glue prior to installation. Time will tell...brain

The original feet for my patio chairs had a screwed on plastic piece that had rounded out section that fit the chair. As you can see in the picture, the plastic had worn down so much that it also wore down the screw and was scratching the finish on my patio. I could not find a replacement anywhere that looked the same. I purchased these U-shape floor guides and to make them work I had to drill out the hole to a bigger size so the tongue of the floor guide would fit in. Since these chairs are used on a concrete patio I don't expect they will last a long time so I'm buying extra to keep them on hand.

These guys work perfectly on my Mies van der Rohe is Mr Chair frames. Of course I had to cut out the nipple to make them fit, a tedious but easy process with a sharp X-Acto blade. We have tile floors and they have not marked them so far.Excellent price, especially considering how customers are gouged on the “authentic” Mr Chair glides. I am going to get another set to have on hand.At $8.69+$2.06 S&H (11June2021) for a dozen of them…Highly recommended.Note, Amazon may have cropped the pic but you can still see to modification to accommodate the Mr. Chair non-holy frame.

Initial fit was fine (I did order the correct size for our zero gravity outdoor chair), but these slip out of position so easily they are useless. The pin does almost nothing to prevent these from rotating out of position. The material is just too soft. If you buy these, be prepared to apply some form of a good double sided tape to the inside of them before snapping them onto your frame and maybe that will help for a while.

I do recommend these simply because after an exhaustive search, they were the only choice of what would work on my aluminum swivel patio chairs with round tubular base.I rated a 3 because I had to cut the molded stub designed to insert in replaced screw holes.... but they were too "fat" for the holes in my chairs. They "clip" on just fine and the cut nub still helps the slide stay over those old screw holes.I was disappointed I couldn't get a thicker, more robust slide... these are thin, and on a concrete patio floor, your round tubular base still scrapes on the floor and is noisy. I was hoping to eliminate that noise with new, better slides. BUT.... these are better than the deteriorating old screw-in rubber feet.