Fastronix 3/16" Small Stud Terminal Covers 2 Red and 2 Black

The media could not be loaded.  These were just what I needed to protect and insulate the end terminal connections and complete the power winch snow plow lift conversion on my Craftsman lawn tractor after ordering and returning the wrong set of terminal covers previously that were both advertised to fit, or some reviews saying that they would, but they absolutely did NOT. These Fastronix ones were very accurately described to fit 3/16" stud terminals having 10 gauge wire and smaller, so having the larger 10G wire size I had to cut the smaller tails off flush on the ends for the wires and terminal ring connectors to be able to slide through the boot cover for a perfect fit on my installation, they are very good quality and I have a spare pair if ever needed.

The Fastronix terminal covers are quality parts. I've used 3 different sizes of them, and they work great.

Fit snugly very pliable perfect fit to cover terminals on a winch solenoid

Good quality

The current Fastronix 3/16" Small Stud Terminal Covers #404-122 is not what is being shipped. The package received has only 1 pair although showing 2 pair.Customer service responded to my complaint within a couple of hours that that was not acceptable and they were looking into it. They then offered 2 pair for free. Within 10 minutes of accepting their offer, I received an email with the tracking number. It doesn't get any better than that.The covers are just as great as the customer service. They are well made of soft but thick flexible rubber (wish they were more Red than Pink) The nipple fits tight to snug on AWG 14-10 Bonded Zip cord type wire. THNN wire types will be loose on AWG 14. (since I had already installed my connectors I had to trim the nipple a bit). These are a great looking addition to my diy ham radio battery box.

I was replacing the starter solenoid on my ATV and needed to replace the nut covers this worked great.

These work very well on 1/4" studs on my bus bar and grounding blocks. Used them to keep everything clean when building an aux fuse box and relay box. I will use them again when I upgrade my car grounding wires.

I bought these for my atv winch mount wire covers. They are a bit small but they covered what I needs for. Just a bit small and hard to put on and take back off. Also a bit pricey for only a couple. But they work so no complaints