ORACLELighting 5874-504 Rear Bumper LED Reverse Lights fits 2018 2024 Wrangler JL - Over 1000+ Lumens, Clean Design with OE Fitment

The fit was exact. To get that 7mm screw out you need a flexible extension shaft for your drill. I didn't bother to try to put it back. I just siliconed them back in. Fishing the wire up to the tail light was probably the hardest thing. I used one of those springy grabbers for that. The wire connections worked just fine. Only issue was "red" wire on new light was not red. Closer to brown.Although not the fault of this product, I'm still not happy with the total light. These significantly help with the camera but when looking out the back window I could use more.

I have two pieces of advice, accept the Lord Jesus Christ as your Savior, and take the bumper off, when installing in a wrangle JL. Unless you have long skinny alien fingers you will lose your sanity trying to get the reflectors off. After the physical removal and install of them light, it's all down hill, easier to install into center wire of 7 pin trailer hitch.Automatically comes on with reverse lights, I also ran a wire from aux 4 inside cab back to right taillight, found the trailer hitch wire and attached. So I can also manually turn on when you need some light behind you when not in reverse.

They are awesomely bright and good qualityThe Jeeps bumper is a bear to work with to install these. I’m pretty mechanically inclined and have a broad selection of the right tools. Time to install was ~4 1/2 - 5 hours.Oracle’s instructions were good and clear but that rear bumper on the Jeep is tough to work with to mount the lightsThat said, I’d still buy them again , lol

Does not fit factory steel bumper! Had to shave down the housing just to fit the lights. Now the drivers side has water in it. Don't know why the description doesn't include this important fact.

I love these lights now that I have them installed and properly connected. Super bright and this makes the backup camera actually be clear.Install is tough. I found it easier to install with the bumper removed (had it off for a different install). I did have to grind down the opening or side of one light to get it to sit in there correctly.The other issue is the wiring. The t-clips are easy, but not sure if the wiring changed on the 2024 Wrangler as the lights did not work when connecting to the wires specified in the directions. I later ordered the plug and play wire harness and then super simple. Just include that from the beginning.

Work great and are very bright. I wired mine up to aux 4 switch so I can use them when needed

Poor fit on the driver side, passenger side no figment issue but the wires are exposed. I’ve been trying to get a replacement. This is on a factory Rubicon metal bumper. Contacted customer care and the response has been pretty much non existent.

These lights are super bright, way brighter than the OEM reverse lights. But the install is basically impossible to do without removing the bumper.I was able to remove the screw from the reflectors but I ended up just using 3M double sided tape to install the new ones because I couldn’t get the screw in. The wire is also a tad bit short.Other than the install, great lights.