Spigen NeoFlex Screen Protector Designed for Galaxy S22 Ultra (2022) [2 Pack] - Case Friendly

The screen protector fits perfectly with Spigen tough armor case. There is no peeling off on the curved edges or the top or bottom side after a month of use. The fingerprint sensor works without any issues as well. Installation is simple but not easy. Keep the phone in your case, as it helps to line up the edges. Start with the top aiming the camera cutout with the front camera and then slowly place the protector while lining up the edges with the phone case. if there is slight unevenness, you can move the protector as it will be sort of floating on the liquid. but once you set on the fittings, you can start squeezing the liquid out with the plastic card. first the front side of the screen, then the curved edges. once you are sure that all the liquid is squeezed out, and there is no air bubble, leave it overnight to dry. Good Luck.

Tempered glass protectors are just too PITA to install and still can crack from impact damage, I hated how my whitestone worked on my Note 8, so I didn't bother with my new S22 Ultra either Spigens soft film is easy enough to install IF YOU FOLLOW THE DIRECTIONS!! Be sure to get a clean, flat and dustless table as possible to make putting on the film much easier and avoid "dirt bubbles" The film reduces glare nicely but still allows the screen to be very clear and sharp. I've had no issues with my sonic finger reader after apply film, didn't need to redo finger scanning at all. The film will old "dents" or hard hits or even S-pen traces if you push hard, so if that bothers you, look elswhere

This fits really well with a Spigen case and it is definitely better/easier to install with the case on the phone. It does seem to leave the smallest of gaps around the edge of the screen and it would probably not have 100% coverage outside a case. I got this one specifically hoping it would avoid the issue of the edges of the protector rolling up because the case keeps chafing it. The fingerprint reader works perfectly through it and no need to increase the touch sensitivity for regular use either. The only downsides seem to be that it is a little more difficult to install because it's hard to get it off the stiff plastic card it comes on. It took a few tries with the spray to move it around into the right position and try not to crease it too much. If you try too many times, you end up having to clean the screen again because you're bound to introduce some dust that will get stuck on it. Also for what it's worth, don't expect it to prevent your screen from cracking after being dropped as no screen protector can really help with that. I did have the misfortune of shattering the screen on my S22U and this protector definitely helped me keep the phone usable while waiting for a replacement as it prevented any glass shards from splintering out and cutting my fingers.

This was suppose to be a much better fit for the S22 Ultra then other protectors as its flexible and suppose to fit the entire screen rather then just the flat portion. It is misleading at best, and straight up false advertising at worst. The edge does not cover the entire screen, due to this there is a lip on both sides of the phone that will easily lift off this "Protector" and pretty much make it very easy to pop it off by mistake. The protectors themselves leave streaks and marks, even while perfectly following the directions to soak the hands, device, and protector with the solution, it still has some imperfections on the "screen protector" itself that do not come out. I would advice using something else, this one does not cover the entire screen and is quite easily removed accidentally if you lift up the phone. I do not expect this to last very long on the screen.

Easy application, A+,Fit perfect

Usually the first purchase I make for a new phone is a case and screen protector. With many of my items, I try to get something that I feel is a good value for the use. This was far cheaper than some of the ones you find in retail stores, which is a huge plus for me. I've also tried the glass version of screen protectors and had issues with the finger print reader. This one seemed to work pretty good. But there are some flaws with this as well. Here are my pros/cons of this protector: Pros: - Price: This is a decent price to protect your screen. I picked mine up for around $12, not the $25-$40 ones that are usually sold at the phone stores. - Protection: This will protect against scratches from normal use. My old phone does not have a screen protector on it, and you can see where I slide my finger the most. This one should protect my new phone from this. - Fingerprint scanner still works, unlike the glass ones that I've used in the past with other phones. Cons: - Adhesion: I have issues with the corners wanting to fold up with my case on the phone. I've pressed them down, folded them under the case, and even tried removing my case for a while to allow the corners to stick, and they just refuse. - Protection: Unlike the glass type protectors, this one will not protect against screen cracking if you drop something on the screen or end up dropping your phone on its screen. - Installation: I found this one to be a little harder to install than the glass protectors. Since this is like any soft product, you have to be sure to hold the sides while trying to get it on straight and get the bubbles out. - Does not cover the sides Overall, i am satisfied with this protector, but a little disappointed that the corners keep folding up. This would be a 4 star product if that was fixed. The other issues are minor, but the fact that it keeps folding up is annoying and leads to dust and other things getting under the corners.

Habe die Schutzfolie für das Samsung Galaxy S22 Ultra gekauft. Ich fand die Installation einfach, und nach 12 Stunden ist die Folie so gut wie nicht mehr sichtbar. Sie ist Blasen und Hubbelfrei. Der Fingerabdrucksensor funktioniert 1A. Fingerabdrücke bilden sich nach einiger Zeit (Und das ist kaum vermeidbar), gefühlt dauert es aber um vieles länger als wie z.B auf Panzerglas. S-Pen Abdrücke gehen nach einiger Zeit wieder weg, wenn man nicht zu stark drückt. Nun zur Installation der Folie, so wie ich es mit TPU immer mache : Nach dem Auspacken habe ich das Gerät so gut wie möglich gereinigt mit Microfaser und Alkohol. Ich fand die Installation alles im allen sehr einfach und durch die Flüssigkeit die man auf das Display + Hände sprüht auch sehr flexibel. Die von einigen hier kritisierten Blasen oder das die Folie abgeht, sind in meinen Augen reine Anwenderfehler. Mann muss : 1. Das Display 200% Staub- und Fettfrei haben, also sollte man das nicht unbedingt im Wohnzimmer machen. Hände sollten vorher gewaschen und damit trocken und möglichst Fettfrei sein. 2. Flüssigkeit großzügig auf die Hände und Display aufbringen. Lieber bisschen mehr als zu wenig. 3. Folie vorsichtig und möglichst grade aufbringen, und minimal verschieben und glattziehen wenn es nicht direkt 100% passt. 4. Danach das Wasser und Blasen rausrakeln, das ganze vorsichtig von der Mitte zu beiden Aussenkanten drücken. 5. Wenn das sauber gemacht worden ist, sollten schon sehr wenige Restblasen und Hubbels sichtbar sein. Jetzt kommt wie auch schon andere sagen das wichtigste : Kanten nachziehen, aber von Display zu den Seiten leicht schräg. Viele (Selbst erlebt) machen das Schlicht falsch und rakeln am Rand vorbei von oben nach unten. Damit verzieht man die Folie, und sie wird sich lösen. 6. 6-8 Stunden ruhen lassen, damit die Restflüssigkeit trocknen kann. Nach 12 Stunden liegt die Folie absolut glatt auf. Alles im allen Spigen ! Top !

Easy to install and comes with everything you need to I stall is bubblefree

I recently had an expensive glass screen protector fitted at a kiosk. It looked great, but lasted about a week before cracking. I had this as a backup in the drawer, but I'd been avoiding using it because I thought it the process would be epic. After watching a quick application video (worth watching before you start), I installed the guard in about 20 seconds! It was so easy. Next challenge: Wear and tear - I had read the guards get micro-scratches but it has been a month and the guard still looks pretty good, I think you would have to be storing your phone against keys (or similar) to really scratch it up. And the best part is that it comes with a spare, so when this one gets really scuffed up, I can just easily replace it! Great guard!!!

I tried GlassDome previously, although it saved my screen, the protection layer got destroyed and had to be replaced. Having that said, finger print didn't work properly, trying to record on WhatsApp was not working properly (given the location on the extreme side). With this I can use my phone as if I don't have a protection screen on. Only test remaining which I hope I don't have to again, is a drop test :). It was pretty easy to install as well.

This Spigen product is the worst one that I have ever bought, it is a terrible product, I watched the video and that looked pretty simple, but it started already bad when I was trying to get the backing off, then the product is so flimsy that it is hard to get onto the screen straight, the because the s22 phone has a rounded edge I could not get the product to stick properly, I will not recommend this product.