Pioneer A-Series Plus TS-A709 2.75" 2-Way Speakers (Pair) – 600W Max, Balanced Sound + Smooth Treble, Great Stock Replacement, Easy Installation

I'm thrilled with my new speakers! I have a 2014 Nissan Frontier, and after my front dash speakers failed, I purchased these on a whim. Installation was surprisingly easy (Note: minor adjustment of the mounting brackets was needed for my Frontier, but otherwise, they fit perfectly). As an audio enthusiast, I'm impressed by their clarity and enhanced bass response. The sound quality remains excellent at both high and low volumes. I highly recommend them.

These fit many Toyota and GM vehiclesEasy installation just bolted right up in place of the stock dash speakers.These are great with a pair of 6x9 components in the door as they give the mids and highs that are missing with the 6x9They have caps on them so don't need a crossover.Very clear and clean sounding speakers that can handle a bit of power.Not so much bass that it rattles your dash apart.

Excellent sound quality, crisp clear highs and upper mids. Would buy again, fit well in stock 2022 nissan frontier dash.

The speaker sounds great. Thank you.

Great speaker this replace oem standar in my Mazda CX30 2025 is big diferente

I installed these in my 2024 sierra after being unimpressed with the memphis audio's I had. I have kicker ks series in the front and rear doors on a kicker 720 amp, and the pioneers are LOUD... Im very impressed at the clarity of these little guys.

Perfect fit for a 2023 Chevy Silverado without Bose.

These Pioneer TSA-709 speakers are a perfect drop-in replacement on a 2019 Nissan Frontier and greatly improve the sound quality of the standard OEM/factory stereo system.Here's how to install: First, use a really thin pry tool to pop the speaker cover from the dash. (I used a pry tool designed to open a cellphone case). Next, use an 8 mm socket or wrench and/or an offset/right-angle Philips screwdriver to remove the three bolts holding the OEM speaker in place. Then cut the OEM speaker wires. Move one of the speaker opening's screw clips to the mounting hole that doesn't have a clip on it. Next, connect the supplied crossover's leads to the cut wires. (I used Posi-twist connectors rather than solder. Make sure you identity the positive and negative wires correctly). Then connect the crossover's wires to the speaker terminals. Drop the speaker in place and install two bolts. Finally, pop the speaker cover back into the dash.These speakers filter out the low end frequencies that muddy the sound coming through the OEM speakers. Mids and highs are now nice and clear. Swapping out the OEM tweeters with these Pioneers is probably the best bang for the buck improvement that can be made to the OEM sound system.