Performance Plus CartsEZGO Golf Cart Powerwise Charger Board - Control and Power Input Board Replacement 28667G01

It turns out that it was not the issue but it works and the old one was corroded so I just left it in.Do be aware that the wires are different from the OEM one that was in the charger. The proper wiring was easy to find online but it did make me scratch my head for a few.This was for a friends golf cart and I tested everything in the charger and ruled out everything except this board. when I replaced it, the charger still would not start. as it turns out, my friend had let the batteries go completely dead. Power from the batteries is required to activate the relay on this board which in turn starts the charger. If the batteries are flat dead, the charger will not start. You can find info online about how to bypass this board and get the charger going enough to put some charge in the batteries (assuming they are still chargeable). Once there is enough of a charge to trip the relay, the charger should start at that point. Of course, this is for informational purposes only and if you are not qualified to work on electronics you should not open your golf cart charger as there are zappy bits in there that could make you dead.

Overall it works well. It is an updated board, which can be confussing, at first. It actually replaces both pc boards in the power wise charger. They sent poor instructions. Whereas the instructions explain to remember where all wires are connected, you actually need to do what their picture shows. The wires will attach very differently then before but take a second to look it over. Then it will make sense. remember, you are not using the vertical board any longer.

Installed borad via YouTube videos because the instructions were not clear. Plugged cart in and nothing happened. Almost trashed the charger because I was told my an expert if the board did not fix the problem that it was not worth fixing. I ended up finding a video on the internet that showed me how to by pass the board. I did so just to make sure that it wasn't another part of the charger malfunctioning. Charger is now functioning with bypassing the board. I would not recommend doing this as a permanent solution because the charger will not turn off when batteries are fully charged. However I now know that it will not cost me 300 dollars to replace my charger.

Fit my charger ezgo powerwise 28115 model number. Very easy to install adequate instruction, much less expensive than a new charger

I have the older charger with two boards in it, i.e. going from two boards down to one. With aid of a YouTube video it was a 10 minute job and charger is back online.

We had some issues with the installation of our board and contacted customer service for assistance. They were very prompt to reply and very helpful. Problem solved and we would buy from them again.

I almost bought a new $300 charger because mine would not come on anymore upon plugging it in. I tried replacing this board instead and the charger works perfect again.

Installation required some modification and their were no instructions on what to do. I am lucky that have a strong electrical an electronics background. This module actually replaced 2 modules, the other module was not needed in my case. I bypassed the other module and charger works great again with the single new module.