Atflbox Ferris Wheel Metal Resetting Mobile Shooting Targets for Pistol Airgun Air Rifle

It is easy to assemble. The targets will not fall for airsoft pellets. I tried .12g and .25g, 300 fps and 325 fps. It will make a nice BB target, so I will use it for that.

Suitable only for shooting small balls from air guns.

I bought this without reading cause I'm a fool. I intended to use this at an actual range. Even when I found out this was for airsoft I went and did it anyways, and to my surprise it held up ok at first. It can handle .22 easily enough (just don't hit the frame). Any other caliber would absolutely decimate it. Ended up blowing this thing into little bits of shrapnel with 9mm when I hit the center of the wheel on accident.

DOES NOT spin/reset. Legs/stand WAS not threaded properly. Had to table clamp and grind down, force the legs to screw on.SPEND YOUR MONEY ON LITERALLY ANYTHING ELSE.

Bought a new target for my sons Christmas present only for him to open it and find out it's been used!!! Frankly that kinda tics me off. Quality seems ok but I can't get passed the fact of them sending me something used already when I wanted new!

The media could not be loaded. I'm going to have to rebuild mine. It went boom LOL! With 33.95 JSB King Heavy MKII pellets at 750 fps (42.4 ft pounds of muzzle energy compared to 7.8 with a Daisy 880 in .177) it blew the plastic hub apart by ripping the arms out at 20 yards. One arm sailed back 5 feet. The paint on the back of the orange target is splitting from being dented out. The paint on the front is halfway to the moon. :-)My solution will be to rebuild the hub out of aluminum (I have Boeing surplus nearby!), move it out to 40 yards and put a regulator on my Blitz so I can dial the pressure down a a wee bit. It will survive that.Overall quality of the product is really good, just watch the video and see they are not kidding when they say it's not meant for PCP rifles. Not asking for a refund, it was cheap enough for my experiment.(Scope is a PARD DS3570LRF(940NM)5 stars. Cheers, everyone!

I had high hopes for this spinning target system. I was using a Hatsan Flash Pup 22 cal PCP air rifle. It isn't a weak air rifle, but certainly not one of the most powerful out there. My first shot not only dented the metal, but made the whole thing "cup". Also, there was so much force that it would pull the spoke out of the hub and you can see them laying on the ground. Finally, when you hit the target it causes all of the spikes/ spindles to shake free and either open or close all at the same time. The magnets are not powerful enough and the resetting of the target doesn't work as it flips back to reset with so much force that it simply snaps back again. Not sure what you are planning to shoot with this, but perhaps a BB gun or low power "pump" pellet gun, etc.Do NOT think that this will work well for any higher powered PCP or worse yet, an actual 22 long rifle cartridge. That would quickly destroy this target system.Just so you know....

Endless amounts of fun. Functions as it should and good value for the money .improves target accuracy.