ECOELER PIR Ceiling Sensor Switch, Hard-Wired Occupancy Motion Sensor with Slim Design, 360 Degree Field of View High Bay Ceiling Motion Sensor, White, UL & FCC Listed

Great product, highly recommended, will buy more

I got tired of having to turn my garage lights on from the switch outside the door in my den, so I had my friend hook this up right next to a ceiling outlet that I daisy chained a few led tube lights that I mounted. Works great and does have a few separate adjustment knobs on the inside of the light in order for it to work the way you’d like it to. My only small complaint that I have and why I didn’t give it a full five stars is that this item does not capture a long distance well. After many adjustments, the best I can get out of it to turn on is when I’m about five to six feet from it. If your looking for something from a very far distance, I’d not get this product, but if it’s used in a smaller space, this will work fine.

In the mid-2000s, I set up outdoor lighting to go on depending on a separately mounted sensor. The world has moved on since and so did my old sensor. However, putting in a different sensor system would, in the least, leave a hole in my stucco. Finding a new sensor was the answer, and this one was hard to track down.It works. It is supposed to be indoor only, but I suspect that under the eaves in a non-freezing climate, it doesn't really know that it is outside.

I removed my old spot lights and added a couple of Juno LED lights. However still needed a motion detector to trigger the lights. I have been searching for an exterior motion detector that was minimal in size, nothing large or protruding. I researched this product, even though it says for indoor use, and it works like a charm. It is installed under the eave, so it is protected from direct rain. I also sealed all of the edges with silicon for added protection, so time will tell.Cheers,Danbo

Installed device. Never worked properly. Would short cycle when you were in the room and sometimes never shut off after you left the room. Finally just quit working altogether. Buying another brand this time.

Works ok but not a lutron sensor. Probably wouldn't buy again.

Works as expected, many settings for sensitivity and length of timer.

Installed it a week ago to add to our walk-in closet. It performs as expected, but I wish I had more control over the time delay. While the adjustment seems to be a variable resistor, all I can get for delay options are 15 seconds, 5, 10, 20, and 30 minutes. So a simple task like grabbing a shirt off the hanger might take me longer than 15 seconds (at which point it blinks off then back on as I'm still in the room), but definitely not 5 minutes, so it doesn't really save energy.