textile solvent free fabric glue 19ml

I used this glue to repair a split in some waterproof walking boots. The glue dries transparent so the repair was hardly noticeable and as it is flexible the repair held up to many long walks in muddy and wet terrain saving me from having to buy a new pair of boots. The glue itself is easy to use and once it started to set and became tacky, I pinched the material tear together to create a good seal until the glue was fully dried. As I only needed a small amount of glue I store the rest of the tube in the freezer to be able to use at a later date.

UHU is really adhesive and dries quite quick. However it doesn't work on some fabrics. Apart from that, it is a good little product!

I bought a new car and it had a small scrub tear in the lining by the seat belt which was unsightly, so before i went don the route of buying a new interior piece thought i might as well give this a shot. I applied a small amount to the tear on both the base and the backing of the tear, the glue is very fluid a bit like watery PVA glue, so i left it to set a little for a bout 15 minutes then pressed the two areas together and held them there for about 5 minutes, this provided the adhesion needed to bond the two surfaces together, i then left it for about 15 more minutes with the heat on in the car and overall the the two surfaces bonded and the glue dried clear, albeit leaving a little bit of stiffness on the surface. Overall the lasting result is perfect and has saved me the hassle of buying and fitting a new piece to my car, so i am ecstatic on the finish. Just be careful with how much you apply as it spreads really well, however if you apply too much you can wipe away with a damp cloth. Delivery was great, came the next day and saved me loads of hassle, well happy.

Didn't impress me at all. Didn't work, stick to needle and cotton

Good, as advertised

This product is appalling! Do not buy it. Despite following the guide to the letter it didn’t stick and has frankly ruined a brand new cubs sweatshirt. Sticking on the cubs badges should have been easy. The glue didn’t even last a single wash and has utterly ruined a brand new top. I’d quite like my son’s sweatshirt to be replaced. As you can see in the picture not one of the badges stuck and the glue left awful white marks on the top too. I’d definitely avoid this product in the future and stick to a needle and thread.

Genuine brand, good quality and easy to use.

I used this inside shoes to add a new lining. The material was a very thin sports type material . It did stick it but was quite hard to keep in place while it dried as the consistency of the glue is runny and thin a bit like a PVA The colour was very slightly darker when dry . You couldnt use this for adding an invisible patch on thin material as it would show too much. This one tube was just enough to do the lining in the two pairs. My material was not very thick and absorbent but I would think that had it been so, the glue would not have spread very far. however the area of material it was used for was approximately 8 by 8 inches and I used it liberally. I did stitch the new linging on after the glue dried as some places werent perfectly stuck but this was more about gravity trying to remove my vertical material , where it was able to lie flat while drying , the glue held really well.