WAPANE 90" x 3.1" Peel Stick Foam Molding Trim Self Adhesive, Crown Molding Wallpaper Border Flexible, 3D Wall Edging Lines Foam Baseboard, Wall Base Moulding Trim for Home, Hotel DIY Decoration

The cut out hole in our ceiling was larger than our bathroom fan replacement. Not a perfect solution, but definitely the easiest! I did have to paint the trim a bright white after installing it. I rushed the job, so the lines are not perfectly straight, but that was my fault! Looks better than it did before!!

Don’t waste your money. It’s painted styrofoam. The white would probably be fine but the black you can see white styrofoam from every cut you make. Not worth it. I can’t even take it off because the sticky part pulls off on whatever surface you put it in and you can’t get it off.

Works great. Flexible and sturdy

It does the job. I wanted it because it’s lighter than actual molding, I was doing a DIY frame TV. The adhesive is very strong and it will leave thick residue and parts of the foam if you rip it off, so I put painters tape behind it. I wish it wasn’t textured but it has to be to hide the wrinkles from it coming in a roll.I got the white because I wasn’t sure if I liked the gold, and I painted it with acrylic paint. Definitely needs 2-3 layers and the first layer is a little tough because it’s like painting plastic where it wipes away if you brush over it a few times. If I could go back in time, I’d buy the gold and paint over it with the gold I like so the first coats basically done for me and I’m not trying so hard to cover the white.Pretty easy to use. Extremely easy to make a crisp cut, I just used kitchen scissors.I wish the edges were cut better. There was a little overhang I had to cut with scissors myself (see photos). It’s also difficult to get it to lay flat if it’s hanging off a surface like the corners are on my tv, I just put a piece of heavy cardstock for it to stick to so it stays flat.If you’re using it for the same DIY frame TV project and you’re worried about your remote working because you have the sensor covered, I bought an IR transmitter so i could redirect the sensor down below and have it blend in with my plants.Wish it was a bit cheaper though. One roll only did half my 55 inch (I didn’t measure, I assumed I’d get enough and wasn’t thinking about it). The adhesive is powerful but you can reposition if you don’t push it down too hard the first time.

Didn’t always stick to the wall had to use more glue

I've bought quite a bit of this for a quick makeover in a room until we were ready for something more permanent. This is foam and easy to apply. It is very sticky so make sure of your placement on the wall as peeling it back up will leave bits of the backing behind. That isn't a big deal if you are going to reposition it over the backing. I've ordered the 2 pack a few times but this last order the two rolls are slightly different. The top part of the second roll has a wrinkled effect and is a bit shinier than all the other rolls I have used. It also was a little shorter in length. The only reason I'm not returning it is it is meant to be temporary and will not be that noticeable where the two rolls join. It will however stop me for purchasing more in the future.

Me encantó , se ve hermosa en mi baño 🥰

You get what you pay for. Does it look like wood crown molding? Kinda? Does it look like Styrofoam? Yes. However, after it was painted I thought the effect was pretty. The price was great. It stuck to the glass too well and was hard to get off. It stuck to the wall not so well, but it did fine after I used a little sticky putty. It will definitely leave residue, so be prepared for that when ypu take it off. It is going to get dented easy, so I will not be putting it anywhere with high traffic. It will be perfect once I get it up as crown molding. It paints well, and that makes it blend better.