Pass Through RJ45 Crimp Tool, Ratcheting Ethernet Crimping Tool Kit, Ethernet Crimper for RJ45 Pass Through Connector and RJ11/RJ12 connectors

This is a good tool for creating your own ethernet cables. I've used it several times and it works great. The pass thru connectors makes it easier to verify the wire order before crimping.

Exelente producto sin duda lo volvería a comprar muy recomendado

Awesome tool. Don't trust the RJ45 connectors. I went through all of them and still couldn't get a complete connection. Bought new connectors and it worked the first time

The media could not be loaded. First off, I searched high and low, both pricing and reviews for a RJ45 passthrough crimping tool. Ranging from $10 to near $100. I cashed out some forgotten Microsoft rewards points for amazon gift cards. That got me $14.Looked and sorted and found this. Paid the tax and got it in a few days.1st attempt was poor. I didn't cut the legth of wire right and ended up with a 2 wires criss-crossed. - so one wasted connector.2nd attempt, better, wires were right, but they didn't get cut properly. - Another wasted connector.II was about to go ham and write a bad review. I calmed myself, tried another, this time turning the crimper so I could see the ends, so facing me. Squeezed hard and quick, and PERFECT! I was so happy.I immediately started making 3 ethernet cables I needed to wire my basement, it took just a few minutes each and worked each time with full speeds.Oh, And IT RATCHETS? I wanted a ratcheting crimper and didn't see one in this price range but was pleasantly surprised.Things to keep in mind!1. make sure you leave about 3" of stripped wire. This makes it easier to unbend and get them in the proper order.2. SLOWLY add the wires into the passthrough connector. Once through verify the order again.3. Push the connector down to the cable jacket. If you need to press down or crimp the jacket so it fits inside the connector (It iwll not crimp to the wires, the full cable AND jacket have to be inside the connector)4. Guide the excess wires and connector into the crimper so the wires are facing you. Once the connector is in all the way, squeeze hard and fast and all of the wires should be cut flush and you'll have a perfect termination.Plug your beauty in and test the connection!

Does what it should. I like that they include a few extra razors which screw on to cut the wires.

Works well for making RJ12 cables, I have a Ham radio with a detachable faceplate that uses them and needed a custom length cable.

Not a bad buy.

On my tester unit ,it always skips 5. Tried new and used cables with same result. Anyone else having this issue ?