FVRITO VM22 26mm Carburetor Throttle Assembly Main Jets Kit for Predator 212cc 224cc 196cc Non Hemi Coleman CT200U BT200X Mini Bike KT196 Go Kart 6.5HP GX160 Clone Engine Baja MB200 Performance Parts

Great little Chinese replica have it on my predator 224cc hemi. mini bike. didn’t notice too big of a performance gain but looks super cool and definitely made the throttle more responsive and efficient then the original carb this motor comes with. depending on how you tune it, it pops and bangs which I love. the size is just right to fit on my 100cc frp frame. I hit a top speed of 57 mph in this bike with drive gear 10t and driven gear 40t.

when you disassemble it use blaster on the screws sl you dont strip them put a 115 jet in it and when you start it tune the fuel mixture screw to the highest rpm then tune the idle down if it hesitates when u accelerate move the clip on the pin on the slide one down the youtuber black 66 will show you everything

Had a problem with first carb I received the seller replaced with no problem. 2nd carb works great way better than the stock predator carbs. be sure to clean out carb before using remove float bowl spray with carb cleaner to remove any debris and spray out jets. the main jet is to small for the 212 predator I used the 110 main jet works well. If you need more power use the 120.

Saw a lot of good reviews... but this carb was a CHEAP PIECE OF TRASH!!! I am an ASE Master Tech, so it's not like I do not know what I am doing with this carb. I had 3 main issues with it: 1. The order was incomplete. It had everything BUT the throttle assembly. I figured this is no big deal and I'll just keep it and throw the carb on. I proceeded to throw the carb on and then ran into the NEXT issue. 2. The manifold was designed VERY poorly and does not allow enough clearance for the stud nuts. It was able to thread on at first without interference, but as you get closer to the end/being tight it rubs more and more to the point where you can no longer turn the nut. 3. On top of that, the hardware used on the carb is EXTREMELY cheap. The float cover screws must have been tightened by Zeus, as they were nearly impossible to remove. One of them was so tight on there that it immediately stripped out. I then even tried using PB-Blast and vice grips, as well as a bolt extractor, and it still would not budge. I would love to give this carb another chance as maybe I got a faulty one, but I can not justify spending $40 more bucks and wasting more time with it to have the same results. Just spend the extra money, and go with that better carb!!!

it runs pretty good with this carb on it although when it first came in it wouldnt start without the choke on so i had to run a bigger pilot jet i went with a 30 pilot and a 120 main and got it running well without the choke. float bowl leaks is one of the only downsides be careful on the float bow screws they are very tight and easy to strip my motor is a(predator 224 gov delete and a billet flywheel)

Worked great

Good deal but carb needed to be adjusted and didn't know what I was doing so I replaed the parts I needed and used my old carb

Exactly as described very good quality very good look durability is going to remain unknown because someone wrecked the unit I put it on so durability will not be able to be seen