G10 Fiberglass Garolite 3D Printer Build Surface Plate Semi-Flexible Sheet 235mm/9.25"(Black Color),200/220/250/257/310/400mm Available

I recently switched to a G10 build plate on my Ender 3 Pro, and it’s been a fantastic upgrade. It installs just like any other build surface — I clipped it onto my heated bed with binder clips, and it was ready to go. No adhesive or fancy prep needed.The bed adhesion is amazing, especially for materials like PLA and PETG. Prints stick down firmly without needing glue stick or hairspray, but they also pop off easily once the bed cools down. It’s super durable too — no scratches, dents, or peeling like you get with some other surfaces over time.Print quality stayed consistent, and I didn’t have to mess with my Z-offset much either. Just leveled the bed normally, and it was good to go.If you're tired of constantly fighting with first layers or worn-out surfaces, G10 is a simple, reliable upgrade. Highly recommend it!

This is an outrageously high-performance print surface overall, and will last a very long time if you treat it properly.The main selling point for this surface is that it performs well on PLA, ABS, and PETG (and possibly more) without ANY bed preparation, glue stick, etc.PLA sticks like glue at 55C. For a surface this smooth, it has unusually good adhesion. PETG sticks nearly as well at 75C, and adhesion can be improved by slowing the initial layer. ABS is a bit more demanding, but with a slow initial layer, and a high bed temp (100C works well for me), you can print reliably. ABS still occasionally shows signs of lifting in the corners of prints, but it has never caused a print failure.All of these materials will self-release once they have cooled. You MUST WAIT for this to happen, or you will damage the print surface by yanking on your parts.This is a fairly soft surface, and can be scratched and damaged easily. Do not use a scraper on this bed. Do not allow your printers nozzle to drag along this bed. They will permanently damage it. I recommend cleaning it with isopropyl alcohol and a clean rag.This specific sheet (235x235) is perfectly sized for an Ender 3 or K1. The edges are a bit rough, the corners are a bit sharp, but the sizing is perfect.I have bought a few of these, and I find that usually only one of the two sides is perfectly smooth. One side usually has some scuffs in it.

Please note, that I received exactly what I purchased as described, well packaged and shipped to me without complaint. I only give this four stars because I bought this in hope it would be better than the pei plate that I am currently using, It works ok for PLA, things stick but it's not better than what I already have.

Was very nicely packaged in a bubble wrap sleeve and another plastic sleeve inside the bubble wrap but unfortunately when I unwrapped it the product inside was somewhat scuffed up there's no way this happened in transit because it was well packaged product overall is very nice looking I just wish it wasn't scuffed but the functionality should not be affected

Product came scuffed and nothing like the pictured item. Incredibly poor QC. Just pay the extra cost to get a Darkmoon plate, instead of throwing your money out the window.

works great for my 3d printer baseplate.

Great surface that sticks to everything I tried, just use some glue and it can be used for multiple prints. Used transfer adhesive to glue it to a bad and resurfaced bedplate for my Kobra 3.

I print rc airplanes and have switched to a G10 build plate. The cheaper factory 2nds are perfectly fine for set up and evaluation, but once you've got your Z offset dialed in and want a perfect surface, this is the one. Don't forget to clean up with a spritz of IPA and a microfiber cloth every few prints to keep the plate clean!