EVIL ENERGY 4AN Fuel Line Kit, 4AN Nylon Braided Fuel Line Hose Fitting Kit CPE 20FT Black

I used this kit to install an aftermarket transmission cooler on my truck for towing and it worked awesome. I bought some additional crush fittings to tie into the truck but this had almost everything else I needed!I cut the hose by first taping where I wanted to cut with painters tape and then using an angle grinder with cutoff wheel. This left a clean cut and I was able to easily twist the ends on with no vice needed. Just remember to twist the ends onto the hose THE OPPOSITE OF RIGHTY TIGHTY. They are reverse thread and will pull themselves onto the line by just twisting counterclockwise. Easy peezy

The product is easy to install. And it works like a champ.The only thing that the customer should know is that you don’t have the bracket in the kit that I ordered and the fitting for the inlet was too big

Repaired leaky oil lines on my truck, cut out the old section, used Evil Energy compression fittings to adapt to AN, much higher quality and less prone to failure than the replacement parts from GM.This was my first time messing with AN stuff, but it all went really easy, the longest part of the job was getting the old stuff out of the truck. Parts are great quality, seal up nice with no leaks, easy to put together, and include a variety of fittings should you need them.Will look into Evil Energy again next time i need any fittings or line.

Exactly what was ordered and quick delivery.

All the parts fit and go together wellI will be starting this week. I hope it did. You do not leave.

I bought 4awg -12 I haven’t used it up yet, but my neighboring truck started installing those holes on his semi and they looked great.

Good and very hozee

I have a 2017 Cadillac ATS all-wheel-drive with a 2.0 engine, my transmission coolant line started leaking where the rubber meets the metal line after 92,000 miles , they would’ve charged me over $2200 to replace this line because it’s very difficult to do, the dealer quotes 11 1/2 hours ,to do this you have to lower the cradle, which holds the engine, I originally bought the OEM line set here on Amazon for under $95, found out very quickly ,I could not install this myself. Along with this evil energy kit ,I had to buy two 6 AN to 3/8 compression fittings ,that I was able to add to the original line once I cut it in half. Or just pass the oem rubber hose as it meets the hardlines. by the way, the black on the OEM hardlines is a PVC which is larger OD than 3/8. You must take a torch and heat that up and wipe that black plastic off so the 3/8 fitting will fit on that OEM line. Just be sure to check all the fittings for any loose metals from machining and blow that out. And when you’re putting the fitting on the hose, I used transmission assemblee goo which you can get on Amazon relatively cheap , Install the fitting counterclockwise it will go on much easier. Wrapped the line with painters tape before you cut it. Bought some 10 inch Doyle cable cutters from Harbor freight, for $22 was able to cut this with no loose end, used a torch to cauterize the outer nylon jacket edge. Was able to purchase the quick connect fittings for the radiator , these are also 3/8 that goes from quick connect of the radiator to male 6AN most of this is detailed in my pictures. Hope this helps somebody save a big chunk of money, as it did me. One note: I could’ve got by with a 10 foot set instead of a 20 for this job .