Blackt Electrotech BT31FC Fall/Recessed Ceiling Mounted Plastic Energy Saving PIR Motion Sensor Switch with Light Sensor (White)

Descripción

Blackt Electrotech PIR Motion Sesnor The Product is new Energy Saving Device, it adopts good sensitivity detector, itegrated ckt. It gathers automatism, convenience, Safety,Saving energy & physical functions. It works by receivging Human motion Infrared rays. Now Switch ON/OFF your Lights, Bulb,CFL, etc by AUTOMATIC Use INFRARED PIR MOTION SENSOR Life: More than 5 years Use: Home, Office, Shops, Hospitals, Bathroom, Corridor, Step, Parking area & etc QUALITY CONTROL STANDARDS: Operating Volt: AC 220-250V 50Hz-60Hz. Load power: Upto 300/1200W MaxAmbient Light: 3-2000 (Adjuestable) Load type: Incandescent lamp, LED light, CLF, fans, etc Detecting distance: 07M Detecting Angle: 360 Degree. Installtion Hight: 2.2-4 Mtr Motion Detetion Speed: 0.61m/sPower Cusumption:0.1W (static) & 0.4(Work)Working Humidity: less than 93%RH Delay: 10 Seconds -7 Minutes (Adjustable) PRODUCT INSTALLATION: 1.Keep Sensor unit 1.6 Mtr higher from the ground level. 2. The light, such as incandescent lamp which emits high heat should be kept from the switch aways, or it will be turn on/off voluntarily. 3. On being fixed to the wire first time, the switch' initialization will take 1-2 minutes. It's natural for the switch to turn on/off voluntarily. 4. When you install the switch on daytime, the Default State of the switch will make the light off.Keep the detector of the switch from illumination, & then the light will turn ON. The darker, the switch will be more sensitive. If it is not very sensitive, turn the yellow port counterclockwise with a long and thin tool to get a proper light sensitivity. PACKAGE INCLUDES: 1 x Infrared Switch Board 1 x Wall /Celing fitting Plate 1 x Instionas Manual 2 x Mounting Screw Bill Best Technical Support after Selling. Review: The quality is good… but the size of the sensor is too big… I thought it would be of 1 inch… but it is almost 3 inches…. Overall ita nice… Review: It is over all a good product. Finishing is not very good. However cable connecters are of very good quality. Product is quite bulky. I had a LED light in my ceiling before fitting perfectly. But to install it i had to do some retrofiting just to accommodate its bulky body. Still hangs out a little. Other than that working wise works great as mentioned in description. Also can be installed to a heavier load of about 800W. And just so that there is no confusion among new buyers, its NOT a light its simply just a switch that is triggered by motion.