Plasma Cutter, [Blow Back Pilot Arc][Large LED][Air Sensor] 50Amp Non-HF CNC Plasma Cutter Machine 110V/220V Dual Voltage, 5/8 Inch Clean Cut 1 Inch Max Cut, Post Flow, 2T/4T for Beginners DIY

So far it cuts very cleanly on rusty and dirty heavy steel plate without any issue. I have not hooked it up to a table yet that's the next step. I own several plasma cutters but the price was appealing on this one. Is it as good as an American Lincoln, Hypertherm, Miller etc.. no.. it isn't (you can tell by the build quality and durability on the torch but those were 4 times the price)I have found the consumables to be way cheaper than any American brand. If your using it as a hobbyist or light shop use I think its fine. Availability of parts or service-unknown

This works great, has paid for itself many times over with jobs I've done with it.I bought another brand here on Amazon and it broke before completing the first job, have done over 200 feet of cuts now and this one is still going.No external dryer or separator needed super convenient and common air chuck and 220v plug...Never been happier with an Amazon purchase.

Bought the BTC500XP to use on a CNC table since my 500DP caused too much interference. This one works just as good as the 500DP as far as cutting, clean cut on 5/8" mild steel. Very impressive for the price.Only complaint, why not provide a 50:1 voltage output instead of the 1:1 they provide. Wouldn't cost much to add in a voltage divider. Plus, there should definitely be a cover on the 1:1 voltage output. Very dangerous if someone was trying to reach for the power switch when it's running and touches that output.

Entrega rápida y el artículo en buenas condiciones

I cant find any available consumables for the torch. I have not used the machine as of yet. Plus, I've send two emails to Bestarc support regarding the problem but no returned answer. I will be returning the machine. No consumables or support, what good is it ?

This is a great machine. Works as advertised. Had a little problem finding consumables at first but customer service was quick to respond and sent them as soon as they were available ( part number B0D8W7J5RG ) confirmed clean cut 3/4 inch. Couldn't be happier with this purchase and thank you very much customer service for your quick response in getting consumables.

I have been welding and fabricating for over 20 years and have used a lot of different equipment.This plasma cutter is amazing for the money. I can’t think of one bad thing to say about it. This is a great piece of equipment.I am running it on my CNC table and it will get the job done.

Works great, cut steel from 20 ga to 3/8 plate. Should be putting it on a plasma table soon. NTD Racing on youtube has a great review that made me take a look at this.