Question 1

Are the green terminals at the bottom of the switch a set of auxiliary contacts for each side of the switch, I can't find any information about them?

Accepted Answer

the green terminals are sensor ports so the unit may know which side of the switch is currently offering power. 1 and 2 sensors should be connected to the normal supply power and , 3 and 4 should be connected to the stand by power supply , so they may know which side offers power and switch to it.

Question 2

can this be used for a dryer/ ev charger outler? I would like to use my dryer as primary load and ev as a secondary load. So this would transfer power

Accepted Answer

No that's not how this device functions. You might want to look into getting a registered electrician to run a 60-amp circuit in for you, depending on where you are there is a tax deduction for having that done.

Question 3

how do you wire this up for 220Volts?  there is only 1 hot and a neutral?

Accepted Answer

The 2P 220 volt version will work with 220 volts input on both the normal power terminals and emergency (backup) terminals. It is the manufacturer's fault for not marking the 2P 220 volt version input and output terminals as L1 & L2 as in 220 volts single phase instead of L1 & "N" as in neutral. Very deceiving and confusing to the end user. The only difference between the 1P (110 volt version) and the 2P (220 volt version) is the internal components such as the signal relay and the AC motor to drive the gears to move the main switch from one input to another. (as I have both versions and have bench tested them and taken them apart) I personally made my own label for the neutral input side from "N" to "L2" to avoid confusion when installing it. Hope this helps, Michael J, the Electrician, Electronics Technician & Troubleshooter.

Question 4

Can i use this in reverse?  can i have two different loads and switch between them from one 120v power source?  *asking for tech capability not code

Accepted Answer

I don't think so. Probably better to control the two loads so that only one draws power at any given time. You can buy a power switch with an IP address you can control from your phone for $10.

ASIN	B098SCZGZC
Actuator Type	Push Button
Best Sellers Rank	318,620 in Business, Industry & Science ( See Top 100 in Business, Industry & Science ) 122 in Outdoor Generator Transfer Switches 5,575 in Industrial Switches
Brand	JONAS C
Circuit Type	2-way
Colour	Onecolor
Connector Type	Clamp
Contact Type	Normally Open
Control Method	App
Controller Type	Push Button
Current Rating	63 Amps
Customer Reviews	4.5 4.5 out of 5 stars (332)
International Protection Rating	IP00
Item Dimensions	15 x 13.5 x 11.7 centimetres
Manufacturer	JONAS C
Material	Plastic
Model Number	GCQ-63/2P -220V
Mounting Type	Wall Mount
Number of Items	1
Number of Positions	2
Operating Voltage	220 Volts (AC)
Operation Mode	Automatic,Manual
Specification Met	cb
Switch Type	Automatic / Manual
Terminal	button
UPC	791342147163
Unit Count	1.0 Count
Wattage	7030 watts

JONASC 220V 63A 2P Dual Power Automatic Transfer Switch Generator Changeover Switch 50HZ/60HZ

Detalles

Descripción

Presupuesto

Reseñas

Preguntas comunes