CURT 13322 Class 3 Trailer Hitch, 2-Inch Receiver, Round Tube Frame, Compatible with Select Chevrolet Silverado, GMC Sierra 1500, 2500 , Black

Installed on a 2001 Chevrolet Silverado. I was able to do this myself at 75 years old. Vey good to excellent quality. The 30lb weightof thisitem added to the ease of installation as did the installation hardware that was well suited for the job.To install I loweredmy tire to the ground and put the hitch on the tire and raised it up as high as I was able to thenheld the hitch up with one hand and put thebolts in one side at a time.

It took me longer to release my spare time than it did to install these 4 bolts. Lined up perfectly on my 2005 Silverado. Impact wrench the only way to go on this one and done.

Replaced the rotten hitch on my 2004 Silverado. Fits perfectly, now I can tow safely again. My only small issue, there is no bracket for the trailer light plug.

Little hard to install, took some thinking of how to get both ends of the heavy hitch up to the truck and hold it. Found bungee cords did the trick to temp hold near enough to start bolts. Worked great after that.

Purchased to replace a rusted out receiver on a 2013 silverado 1500. A few things to note: The box was destroyed during shipping but the product was fine. A few minor scratches didn't bother me at all. The fit was perfect. I had no issues bolting the new one in place and had no gap between the bumper bolts and receiver as others mentioned. The replacement receiver, in my opinion, is not nearly as good as the OE part. There are 2 bolts on each side vs. 3 on the original. The OE part is braced on both sides of the mounting bolts vs 1 side on the replacement. The OE mounting brackets are significantly longer. The angled holes for the safety chain on the OE receiver are easier to use than the flat holes on the replacement. I can get the chains latched into the new receiver but it's more difficult with the receiver pin in place. The new hitch sits closer to the bumper than the original on my truck. It made my enclosed single axel 5x10 work trailer sit a little too high with the 2" drop I had previously used. I tow a trailer daily. If my truck didn't have 310,000 miles I'd probably have spent more for the OE part but this seems like a decent product for the price if you're doing light occasional towing. It looks fine and doesn't jump out as being aftermarket. I dropped the spare. You don't have to. Takes about an hour. The original hardware is better. Mine was fine so I reused it.

Part arrived on time.Correct fit.

Fitted excellent to a 06 gmc sierra. All hardware included.

It helps on the farm I love it to it put my camper so good