Pack of 2 Front Grab Bar Grab Handles Black Textured Compatible with 2007-2017 Jeep Wrangler JK JKU Car

These grab bars are great. Extremely sturdy. It took a few minutes to figure out which were the left and right handle. Easy to install. Take your time.

I like em. Very sturdy, easy to install. I can put my full weight and they don’t budge.

Great product and very sturdy. Instillation is a pain but once you line them up, it’s just a little elbow grease to get it tightened. Double check to make sure you have the handles on the correct side or you’ll be frustrated an extra 15 minutes for nothing. Big holes should be facing out when are putting the handles in. 13 mm socket and 6 mm hex key are needed to install.

Arrived in perfect condition. Fairly easy to install. Solid after installed. I'd recommend "dry starting" the bolts before attaching the handles as the side bolt is at an odd angle. While I had read that these when these are installed they will interfere with the sun visor. The only issue I've seen is that it allows the visor to come to only a couple of inches of the windshield. Not a factor.

These things look great and work great. These are the best grab bars for getting into and out of the Jeep. Easy to install and come with all the needed hardware. Very strong and they mount up square and out of the way. Take them out of the box, tighten them down, and never have another issue.

Very nice product very strong but I wish it came with an Allen key to install themEasy installationStep 1 remove your 13 mil bolt right next to sunviserStep 2 remove the bolt 13 mil bolt in a pillarStep 3 install the shorter bolt in hole next to your sunviserStep 4 use longer bolt in your a pillar and you are donePersonal noteI recomend you wrap your ratchet with tape or a rag as you could hit your windsheild accidentally but if you take your time you should be good

Awesome Designs ! keep it up

These are nice. They install in the upper corners of the windshield frame. You remove the two Hex head bolts (13 mm socket) and install these with the socket head cap screws provided (6mm hex driver) The socket head cap screws started finger tight for just a few turns & then got very tight. I removed them to see if they were cross threaded, but they were not. It seems the threads just interfered a little. I removed the handles & reinstalled the factory bolts to assure the threads were OK, and they were. I ended up having to use a socket wrench with a 6mm hex driver to get the cap screws all the way home. I think their threads are a little off spec, but the handles are solid & will not likely vibrate loose.