The No-Screwups Remote Control Holder by Mount Genie (White): Wall Mount with No Damaging Screws or Tape. Installs in Seconds on Any Light Switch. Great for TV, Ceiling Fan and Roku Remotes.

Super easy install. I added double sided gorilla tape to give it extra support. It took 3 strips stacked, but worked perfectly.

Such an awesome holder. No holes, no motivations. Just loosen, slip behind and tighten back down. Amazing!

Took less than one minute to install with a small screwdriver. Holds a chairlift remote by the light switch without being in the way. Does lift the switch wall plate slightly away from wall, though not obtrusive. Color is not a match for our ivory plates, but not a seriuos concern. Measurements of product were accurate. Leaves no marls; could be easily and quickly removed and placed elsewhere without needing reparir to wall, paint, or switch/plug cover plate. Purchased two; one for top and one for bottom of stairs. Would not have worked had light switch not been convenient, but would purchase again if location warranted.

Easy to install, won’t damage wall at all once removed, fits ceiling fan remote perfectly; a little expensive though for what it actually is.

This was perfect for what I needed. A holder for my ceiling fan remote. Every store I went to wanted to sell a remote, no holders only. And this one is a double bonus in that it installs easy & doesn't require extra holes in the wall. It's a tad large for what I used it for. Might hold a small TV remote. But does the job at a good price as well as solidly attaches with no worries about it falling off the wall.

I installed this as I kept losing remote controls. It took less than five minutes to install and it looks great! Also, no clutter! This is the second one that I purchased. I love it!

The product looks good and installs easily, but it is too bad that it only comes in black and white. My wall plates and switches are all Light Almond. It would be great to have this in more color options.

This holder is a good size to hold a normal size remote control. I really didn't like the installation bracket that attach the device to a light switch cover. The bracket is too thick to allow the switch cover to sit flush on the wall. See attached picture. I tossed the mount part and used double sided sticky tape to attach the holder to the wall. This way you are not limited to mounting the holder where there is no switch.