- 100 PCS 1.1" White Self Adhesive Cable Zip Tie Mounts Wire Cable Clips Holders Management Anchors Organizer Holders Squares(HS-102)

These work great. The adhesive is strong but they are also easy to remove. Pretty good quality as well.

These are very durable, perfect for managing a 75’ Ethernet cable, adequate size, and adhesion was way better than expected.It is important to note that this adhesive, as with most adhesive of this type, requires firm, even pressure for 10-30 seconds to properly adhere to a surface. When applied properly, these things were so firmly stuck to the wall that we needed to use a zip tie to pry it off the wall. We were honestly astonished to see that the plastic did not break or deform despite the serious amount of strength we needed to pull it off. We were pleasantly surprised to find that it did not pull the paint/vinyl off of any of the surfaces but in single a spot where the paint was already chipping and, even then, it was only a couple specks, it didn’t tear back a strip of paint or anything like that.I did find that this adhesive does not tolerate even the tiniest bit of moisture on the wall, though. (I hadn’t noticed that water had started to condense on the cold wall by the window, but I wiped it down and it worked perfectly.)Perfect for cable management, particularly in our case where we had up to three CAT6 cables in some areas to run long distances together. Tremendous value for the price.10/10, exactly what we needed.

Perfect size...

Good product for the price. Had some issue with them sticking in certain applications but that could have been the wall surface itself not the product. My only issue is getting the film paper over stick pad on some are impossible to get off. You get an abundance so it’s not a deal breaker but very frustrating

I have doubts that the backing is legit 3M, could be. But they do stick well. The key to using any type of foam tape though is to make sure the surface is 100% clean. In my case, with a vehicle, I used brake cleaner (chlorinated) to make sure the surface was super clean. They stuck really good for the wire run I was doing up inside a fender. I doubt if they will fall. They actually do seem better than the GB brand I bought at a local hardware store.

Used these for running my Starlink cable on top of our coach. Worked great and was fast to use

Great mounts for metal wreath signs good price

I don't like the pegs they ship with PCB kits now. I use these nylon tie mounts because it makes it easier to remove and re-base PCBs if you decide to install them into a different electronic housing. The pegs "punch" through the holes of the PCB substrate plastic and I'm worried the pegs will crack the substrate and possibly damage the PCB electrical trace, too.I use the tie mounts for arcade controller (joystick) PCBs. You only need to install two of these two zip tie mounts diagonally from each other to stabilize a PCB in an enclosure (joystick base).I've done things this way for over 12 years now.IF the adhesive fails OR comes loose, you glue the tie mount onto the enclosure with hot glue. I'd give it at least 15 minutes for the glue to harden BEFORE you reinstall the PCB with nylons ties. Oh, and be careful NOT to seal in the holes that the nylon ties slip through. That's the only problem I've had with reusing the tie mounts. You shouldn't run into reusing tie mounts with packs of 100 of these bases unless you're doing a ton of projects...