48A26 PTO Overrunning Coupler for 1-3/8"-6 Spline Shaft Up to 75 HP

Works like it should. A must if you have an old tractor.

Received with cracked c seal , returned and replaced within days. Very impressed

No install instructions! Once I found them online I was able to install cheap made!! Don’t recommendSpend more to get more!! Was using to run brush hogAnd it let loose and came apart!! Was hit in the backBy flying pieces could have been a lot worse!! Ended up damaging my drive shaft in the process very dangerous!!!Where is our quality at these days!!

Works great i have been using it to run a brush hog on my ford 8n.

fit right on 8n tractor and works as should mowing

The PTO overrunning coupler is a good product, but has some serious issues that require attention. As received the item does not work, but can be corrected. To start with, the roll pin (5/16" x 2") was missing from the package. The biggest problem is the holes for the roll pin are not aligned, so the pin cannot be installed without corrective action (disassemble and drilling, milling, or filing).

I needed it for a Super C for bush hogging...works well

I ordered one and it didn't last 30 minutes, was replaced and I put it on and I didn't use for a long time, when I did it might have lasted 15 minutes, when I tried to take my 4 ft brush hog off it came apart and not all the pieces were there, it came fully assembled. it says rated for 75 HP tractor, I have it on a 20HP tractor. again piece of crap.However the company made them all good, the last one they sent looks different, put it on but haven't used it yet.

It works as it should. Quality could be better.