Fast ABS-Like 3D Printer Resin 405nm UV-Curing Non-Brittle High Precision 3D Printing Liquid Standard Photopolymer Resin for LCD DLP 3D Printing(Grey, 1kg)

Does the job but very strong smell.

Súper buena para impresión 3d y trabajos dentales

i have a elegoo saturn and this worked very well i have had no fails using this (apart from my own packing this in to fill the build plate and supports getting stuck to other models). it barely makes a pulling noise from the fep and works fine at 28c (ive had it up to 33c in the vat with no problem) temperature as i live in Aussie and well its warm here. The detail and pigment is on point (4k screen 0.50 layer height no anti a ) and am happy with the results ill be trying in on a mono x and a 4k mini soon to see the differences in res and machines Cons ..... if you drop minis from bench (900mm) height onto tiles it will shatter (ive busted a few small minis like this ) compared to some others its a bit smelly ( i didn't think so until i had used a bunch of other resins) but still not to bad. a bit more expensive than other resins, but hey i only did one tank clean while using this stuff compared to eco and craftsman where eco was after every print (always had at least one fail) and craftsman with the occasional fail , so in that regard maybe not so expensive. these prints were done with - burnin layers 4 exp time 30 trans 0 light off 0 lift 12 speed 40 normal layer 0.05 light off 0 Exp 3 lift dis 7 150/150 lift -retract speed

Me ha sorprendido mucho para bien. En primer lugar, las dos resinas Siraya fast que he probado, huelen mucho menos que otras que he tenido. En cuanto a resistencia/tenacidad, no he hecho pruebas, pero en mi caso no es lo que busco. El acabado de la pieza, mate, en ese gris marino, y el nivel de detalle y resolución, son espectaculares. La figura está impresa con una Elegoo Mars 3 pro (4k) y estoy muy satisfecho con el resultado. Recomiendo 100%.

I princip alla mina modeller har smält/spruckit och inte härdat. Köp inte detta resin!

After trying a few other resins I honestly can never go back. Sirya tech fast has half the oudur which is great for a not fully sealed printing room. The quality and strength is unmatched with even thin bits of models being strong but not too brittle. And faliure rate by far the best feature for me is very low compared to other resins. Its not quite as fast as advertised but it still lets you reduce exposure about 40% on average. The cost is also only slightly higher then the competition. Easy to work with Great quality prints Low smell Low faliure rate Fast prints I wont be buying a diffrent resin for mini printing unless somthing new and incredible is realesed.