WeChance Replacement Key Fob Case Shell for Range Rover Sport Land Rover Discovery LR3 Flip Folding Keyless Entry Remote Car Key Fob Cover

Bueno

Works great for my 06 RRS!

Good product

The key is exactly for the Land Rover Fast delivery Recommended always

I cut the original Land Rover key fob open with a utility razor knife. Removed the circuit board. De-soldered the old battery out of the circuit. Soldered in the new Panasonic battery Panasonic ( 1X VL2330 ) Rechargeable, VL2330 - VL 2330, VL2330/HFN , 3V Lithium Coin Cell Battery, also found on Amazon. Swapped over the original "laser cut" Range Rover key to the new Fob. Use a small Watchmakers hammer and 1/16" pin punch from Harbor Freight to drive out the pins. I had to file the backside end surface of the original key to get it to fit into the swing out key socket pf the new Fob. I used the new blank key from the new Fob as a template. Once that was done, I made sure that the key had the proper spring tension so that it would (switchblade) open once pressing the button. I closed up the new key fob case and installed the included tiny screw to hold the case closed. I was then able to program the new remote using Guy's procedure included below. This worked like a charm on my 2008 Range Rover HSE: The process below worked great for me with both keys. They both now work completely - Thank you Programming a new Key(s) Replacing a missing master key is quite expensive from Land Rover, try not to get sucked into the extra cost of "Dealer coding" You can do this yourself in 2 minutes by following the simple process below. 1) Get in and close all doors. Turn ignition on and off quickly and remove the key (all within about 5 seconds). 2) Within 30 seconds of turning the ignition off, while holding down the "unlock" button, press the "lock" button three times. Release the "unlock" button. (You may or may not get the confirmation from the door locks.) Holding the key at your head level provides best results as the key sensor is in the side window pillar. 3) Repeat for each key you want to initialize within 30 seconds after the last one you initialized (if you have more). 4) Right after doing the last key, quickly put the key back in the ignition and turn it on/off again to finalize.