110V Electric Wall Chaser Groove Cutting Machine with Laser Guide Dust-Resistant Design Includes 5 5-Inch (133mm) Blades for Cutting Grooves in Brick Concrete Marble & Granite

A very useful piece of tool. You need to be strong to use it because it’s heavy.

Was needing to install at my mother in laws kitchen island electrical. The house is on a slab so I had to slot the concrete to do the job. I ordered diamond blades if needed. I used the saw with the blades it came with. Never needed the diamond blades. The saw did an excellent job. I would highly recommend!

La máquina apenas la recibí, en la publicación dice que son escobillas y si las trae no coloquen cosas que no son se le van acabar las escobillas y después van a estar varados porque supuestamente no usa escobillas

Es muy bueno llena todas las espectativas que esperaba de lla

The water pump kept the dust to a minimum, so cleanup was easy with a shop vac. Instructions were written by a non-English speaker, but I figured it out. It cut a straight groove for my conduit to run to my new kitchen island. Money well spent. The rental company would have charged almost as much for a one day rental of a gasoline powered behemoth with a single blade, hence multiple grooves to lay a conduit. This machine, on the other hand had five parallel blades and made a meet groove in one pass. Laser guide. We’ll built. Heavy.

One the best purchase i ever made for my company

I had a drainage problem with my driveway flooding my new barn, and I was looking for a way to divert the water away from the barn. Using this tool I was able to cut a 1" x1" (25x25mm) channel, about 57 ft (17.4m) across the concrete driveway, in about seven hours of work. I'm pretty happy with that, as I am fairly sure that any other solution would have been more expensive. The good: it came with minimal instructions, tubing and pump for water cooling, and (unexpectedly) a set of 5 blades! The bad: it came with minimal instructions, required a lot of force to cut through the concrete, and there was no provision to vary the depth of the cut at all. The shoe on the bottom does not adjust to make shallower cuts. It will tend to wander as it cuts, so you need to fashion a guide fence. I used a 2x8 board with a lot of weight on top of it. I powered it on its own 20A breaker, which it popped twice under heavy load. That may sound like a lot of criticism, but it was a hard job, and it performed. All in all, I am pretty happy with the results, and it's a pretty good tool.

Me encanta esta maquina es liviana facil de usar segura lo mejor de lo mejor

Ranura muy bien llego con un detalle pero el vendedor muy buena atención

Este equipo es lo que esperaba, no te engañan con las dimensiones, eso es lo que más me ha preocupado de un producto, sin buenas dimensiones no hay buena utilidad.

Muy fácil de usar y resuelve mis problemas 10/10 recomendable

No me gustó que el producto estuvo dañado y al conectarlo a la corriente no funcionó.