Bostik GlideCote Table & Tool Surface Sealant

I use this product on all of my woodworking machine surfaces. It is important to first clean the surfaces where you will apply GlideCote. Once cleaned, spray on a layer of GlideCote, allow it to sit on the surface for at least 30 seconds, then buff/rub off with a cloth. I use a buffer pad like you find in car polish. Works amazing! A must for serious woodworkers.

had trouble with condensation making rust on my table saw and band saw tops.. Tried wd40, butchers wax, even car wax.. tried this, and so far it works great.. My shop is not heated all the time, so it's really just temp changes that affect it.. had one so far after using this produck and not a single sign of rust.. and work slides much better.. I will be getting more and reapplying every 6 months or so.. WELL WORTH IT!!!!!

The old version of this product in the brown and silver can personally felt like a better product or formula. This one is still good but is less slippery and does not apply as thick or glossy. Still a good product but you have to use more of it than you would expect to properly cost metal surfaces.

I really liked using Glidecote Table and Tool Sealant because it provided a smooth and slick surface in just minutes. I cleaned and applied it to an old table saw surface and it became as easy to slide as it was when new. Very easy to use!

It is protecting and improving ease of use of my tablesaw.

This product appears to work based on the small amount I was able to get onto my band saw table but the cheap nozzle has made it a one-use only product. Avoid.Upon the receiving the product, I sprayed it onto my new band saw table and wiped it down per the instructions. I went to apply it to my table saw but found that the nozzle no longer worked, thus, I got a single use out of the can. This is a relatively expensive lubricant, I'd have hoped for a higher quality nozzle on such a product, needless to say I will not be buying it again.

I've been using this for years on my table saw bed and various blades etc. On ali or cast it makes the surface really slippery, and lasts a long time. It doesn't 'stain' the wood you are cutting either. I can't recommend it too highly!

I use this product to keep my antique Delta table saw's top looking great and rust-free.