Eurotool Cut Lube, 2 oz

I used to saw my jump rings (10g copper) without this product. I broke several blades. Then I tried lubricating the blade AND the coil of wire where I would be cutting. It is crumbly. But I just reapply more to the blade after several cuts. It's important to be patient and methodical when pulling the saw through the wire coils, pull downward slowly and smoothly. Make sure the blade teeth are facing downward. I apply the product with my fingers. It's a breeze with thinner guage wire. I woulnd't work without this product. No more broken saw blades!

Works as it's supposed to!

Container and contents came intact. I wish I’d looked into this solid metal lubricant a long time ago. Makes sawing and die cutting copper and silver sheet take less effort, and is so much better than sticky beeswax.

I haven't used this product yet as I'm still in the "gathering all the proper materials and tools" portion of my new hobby of metal stamping and soldering. I purchased this item based on its reputation as an excellent product and I have seen videos and tutorials where this product was being used to protect saw blades, etc., and that was enough to convince me that this is a very reliable product. I'm happy with my purchase and will continue to purchase this product when I run low. Thank you.

I discovered Cut Lube when one of classmates mentioned it. I told her my sawed metal pieces looked more like jigsaw puzzles, and required tons of filing. Was also running through my blades (two or more per class). She told me the secret to easier sawing. I tried it and my cuts look much better, I don't mess up a lot of blades, and I have much better control over my jeweler's saw.

I am new to metal work. I started to saw and blow through a few blades. After getting the lube, I went through a class on a whole blade. I will also use it for my cup burrs. It is not smooth but flakes off so it takes a little finesse to just a little on the blade. The push up container makes for challenges to not push up too far as product does stick to the lid.

Flakes just like Pepelube. No matter how well it’s made if it doesn’t stay on your tools it does it no good. I’ll stick with Bur Life.

Cut lube is a very good lubricant for your punches, will keep them like new for a very long time. Makes cutting through coins very easy.