OEM Hyn BC901 256GB M.2 PCI-e GEN 4X4 NVME SSD Internal Solid State Drive 30mm 2230 Form Factor M Key Steam Deck

This chip is compatible with my iPhone 15pro, I have a MagSafe enclosure that allows you to connect a 2230 NVMe SSD to your phone using a USB-C, then you can use ProRes HDR recording. Most people seem to use this for computers, so I just wanted to say that it will work with your iPhone set up! I had to format it to exFAT before my phone would register it. Once it was formatted, it connected right to my dock and worked seamlessly during transfer, and fast! I was skeptical because of the lower price, but this is great quality/storage capacity for what I need it for.

I got thid to use with an NVME hat on an Rpi5 and it works perfectly. I had no problem cloning the SD card over to it then booting directly from this drive. Price is reasonable.

It was clearly labeled as new, but some quick digging on the command line showed it to be a lightly used OEM Dell pull. Still a great value, but not as advertised. My original review contained the specific smartctl and fwupdmgr output which is apparently against community guidelines.

I've bought several of these, and have had no issues with any of them for general computing. Excellent speed and performance.

Worked perfectly in my new Paspberry Pi 5.

Used this M.2 NVME drive to upgrade my 64 gb Steam Deck to 256 gb and it works perfectly. I have about 300 hours on this drive and have not had any issues with performance or corrupted data.

It was not compatible with my computer I had to return Only compatible with newer PC

I purchased several of these to fix a batch of Dell Micro PC's that I had acquired in a lot of electronics. These all worked and worked well. They are the short ones, so if your PC doesn't have short slots (like the Dell Micro PC's do not), you'll need the adapters. You can pick up M.2 adapters very cheap and I like to have a few around just in case. Good luck!

RaspberryPi5用のSSDとして問題なく利用できています。 欲を言うなら2242の方がサイズ的にはベストかも。

great product used it on a raspberry pi linux cnc controller

Bon produit, bon prix, bonne description, livraison rapide.

EDIT: I retested this in a different enclosure with a RTL9210 controller chip, and this SSD performed as expected. The Orico enclosure which had issues has a JMS583 controller chip, so I'm guessing this SSD doesn't play nicely with that specific controller. My other SSDs have no issue with this controller. If you're installing this directly on your mainboard, you probably won't have any issues. Raised my rating to 4 stars to give this SSD the benefit of doubt. ORIGINAL REVIEW: Tested this in an Orico 10gbps enclosure. Crystal Diskmark test slowed dramatically during the Rnd4k read test. Suspecting bad sectors, I did a full NTFS reformat. Formatting started normally but slowed to a crawl about a quarter way through. Did a full reformat a second time before testing again. The second test was basically the same, with sequential Q1T1 reads being very poor, and RND4K reads being so bad it suggested outright flawed fabrication. NOTE: this comes uninitialised so you have to initialise it in Disk Management or similar before your computer can see it.

Inexpensive, used for system startup of backup equipment.