3D Printer Glue Stick 6 Pack, Perfect First Layer Adhesion, Prevents Warping on Heat Bed, Easy Release for ABS PLA PETG Filaments and Various Build Plate, 36g/1.27oz

Game changer! This is great glue for your base plate, I've not lost one print since starting to use it and Im probably up to about 50 prints since starting to use it. It has impressive sticking power, I haven't had one spaghetti detachment since I got it. Easy to use, spreads good and I haven't broke any models detaching, when done, but I have been careful because it holds hard enough Im sure you could. Cleans off great with Isapropyl Alcholol the next day, I clean it in the mornings after printing prior day. Works great for me. Doesent leave gum on bottom of models if you use in moderation. Very Happy will buy again when needed. Smells like a hair promenade I had once 😆.

Brand new to the 3d printing scene. My son received a flash forge adventurer pro 5 for Christmas. We were using the included glue that came with the printer. Glue was GARBAGE!!! We were having constant problems with the print starting out fine but then would get the spaghetti to happen and the print would be ruined due to the print coming loose from the print bed. This stuff absolutely saved the day. A thin coat of this stuff is all you need and we haven’t had an issue since. It almost works to good. There have been times we have had to run the print bed under warm water to get delicate items to release so they wouldn’t break. Very easy. Just note that a thin layer is all you need and the bed needs to be cleaned after a couple of prints. Don’t just keep adding glue. My son did this and it clogged the printer head.

Best glue I have used so far in my printer. Great value and strong adhesion with my carbon fiber prints.

I'll be honest, I tried this glue when it first arrived, and turned my nose up. It looked too thick on the plate to actually work, so I chalked it up to a learning experience and moved on the the spray glue. 2 Weeks ago I was running low on the spray (because I pretty much had to apply before every print), I decided out of desperation to try this glue one more time. I applied it with a lighter hand than before and figure what the heck, lets print something. OMG no lifting on corners, no bed adhesion problems at all and I haven't had to reapply for 2 weeks now. I am a HUGE fan! Great product!

I was impressed with the holding power of these sticks. I have used other brands before and you usually have to use more than recommended, but not with this brand. I put the usual amount I would with the previous types I've used, ignoring the recommended amount specified by the instructions on the package. It was so aggressive an adhesion to the bed of the printer that I broke the legs off of the print that had finished the first time I used the glue. I washed off the remaining glue and on the next print used only the amount suggested. It was more than enough for the print to stick aggressively to the plate.

Works good.but just get cheap glue like Elmer's they work the same

Definitely follow the advice to have your hot bed heated up before application, or you will end up applying far too much. Washes off easily with water and I no longer worry about my large production plates of small parts. Has a fruity/floral scent which goes away in a few minutes after it is fully dried. Not unpleasant, I've gotten to like it a lot. But something to be aware of if you are sensitive.

Its hard to give a negative review, in any capacity, for a glue that sticks things together too well, but, this glue will make it difficult to remove 3d prints from the build plate. You will need to increase initial layer thickness to prevent print damage and probably need a good scraper, but if your prints were detaching from the build plate, this is your cure. Dries quickly enough to print immediately, goes on clear and thin and good value.