Kamehame Ghost Silicone Mold, 2 Packs Ghost Chocolate Candy Molds Halloween Silicone Molds for Jelly, Chocolate, Candy, Gummy, Crayon, Resin

I bought these to make halloween themed wax melts and can't get over how cute they are! Perfect size for wax melts and I love standing them up in my warmer dish and watching them melt down. Cute little eyes and mouth detail as well. Molds (2 piece set) are sturdy and made of good quality silicone, very functional. Easy to fill, easy to unmold, easy to clean up. Would be cute for small cake toppers, chocolates, ice cubes, etc. too. A little more expensive than the flat molds but well worth it!

Easy to clean and use! We made some jello ghosts that were a hit. Definitely need extra gelatin but it was super easy to remove the jello with that. Size is perfect and seems to be very durable. Perfect addition to your Halloween baking/cooking collection!

I love this, I use it for my ice. super easy to use.

Super cute, I just need to get better so they don’t stick

Worked well to create mini jello ghosts. Easy to use, easy to clean, good value for the cost since you get 2!

Ordered these molds to make Jell-O shots for a Halloween party, and they worked amazing!! The jell-o recipe on the box won’t work for these molds, so my friend and I did 5 test batches to get the perfect ratio. I’ll include the recipe below!! One of our ghosts had a small hole where it leaked a bit, but we put a bit of paper towel underneath it in the fridge and it only leaked about 1/3 of the way. Overall was a big hit at our party!! 1 box jello mix 1 1/2 teaspoons unflavored gelatin 1 cup boiling water 2/3 cup vodka Fills up both molds with a bit left over

The mold is cute, but its hard to get it out as the mold is intended for jello. I didn't expect to be difficult, but some do come out similar to it, so its alright

As a 3D printing enthusiast, I often have leftover waste from various prints. This Halloween, I decided to repurpose some of that waste using these silicone molds, and the results were fantastic! We melted the PLA directly in the molds at 400 degrees for about four hours, and the glossy finish inside the molds transferred beautifully to the finished ghosts. They turned out polished, detailed, and everyone who received one absolutely loved them. So far, we’ve run three or four batches through the two molds, and they’ve held up perfectly. No warping, sticking, or signs of wear at all. The durability of these molds is seriously impressive, and I’m confident we’ll be able to keep using them for future projects. If you’re into recycling your 3D printing waste or just want a creative way to make unique Halloween decorations, these molds are a great choice. Highly recommended!

Cute.I have not use them yet but i’m sure it should be fine!