Outside Exterior Door Handle Front Left Driver Side Compatible with 03-08 Infiniti FX35 FX45, 2003-2007 Nissan Murano, 2008-2013 Rogue Replaces # 80640-CA012, 80645-CA000

It fit perfectly on my 2010 Nissan Rogue, driver-side front. It took about 10 minutes.No need to take apart the inside door panel. Just remove the black grommet from the side of the door nearest the lock. Use a torx bit to loosen the screw(the screw should not fall because it's held in place by something). Pull the lock assembly out of the door, enough to make room to insert the handle. It will only move a couple of inches, but that's all you need. The gasket may make it a little stubborn to pull out, so keep trying. Now insert the left side of the handle first, and then insert the right end. As you push the handle into place, keep it as far to the right as you can, in order to clear the latch inside. When the handle is all the way in, slide it to the left, and you should feel it settle into the correct place.For the keyhole cover, make sure that you install it before pressing the lock assembly back into place. You need to slide it on from right to left. I just tried pressing it in and I broke the small tabs which hold it in place. I used double-sided mounting tape to hold it in place and it's working fine.

This seller was quick and the item fit perfectly. I would recommend this eBayer! Thank you!

The handle broke after my wife finished her walk at a local park. I was so frustrated trying to figure out where I was going to get the door handle. I figured I would go to the closest pull and pay the decided to check Amazon. They had it at a great price. It's a perfect door handle replacement. It's as good as new. Found a couple of videos on YouTube to help me get it in.

There are 2 parts to this handle. The long handle and the stop block. The original stop block that has the retaining bolt hole in it is an aluminum body with plastic outer shell covering. The New stop block is 100% plastic so I don't know how long the threads would last in the plastic, if it fit. The shoulder that goes into the door on this new part is too wide to slide into the hole in the door so I had to use my original stop block. Luckily it was in good usable condition. The new long handle was identical to the original but it does not have the teflon sheath on the business end that engages the metal mechanism inside the door. So expect the usage lifetime to be abbreviated compared to your original I tried to move the teflon sheath to the new long handle but it would not fit. But at the end of the day, the handle does work, for now.

This was perfect fit for my wife's Rogue. And installation was fairly simple. Looks just like factory handle

The part that the torx bolt threads into isn’t a match for factory part. Its wider. Pictured on the right. I had to repair the factor part and use it instead. Buy something else.

The description listed this replacement handle for Infiniti vehicles and it definitely is not. Look elsewhere for the correct part.

If I didn't know I replaced this door handle on my 2004 Nissan Murano I wouldn't know it didn't come that way. It looks just like the original door handles. It's been on for few weeks and is also holding up well. It's good quality for the price, especially since one from the Nissan dealer was a hundred dollars. Can't beat it!