VCEUL-Listed CAT6 Keystone Coupler 5-Pack, Ethernet Coupler Female to Female, RJ45 Coupler for CAT6/CAT5e/CAT5, Keystone Jack, Black

They are quality connectors that fit into the wall plate. They simply slide in and look good if you don't want blue connections. They are easy to install for cat 6 cable connections. They function well and hold the connectors in place. Good value for your money.

These are really handy to have around. You can use them as a coupler in a pinch. I bought these to have around when I need to install a wired ethernet cable in the wall. I have a lot of blank plates that these fit. Much easier than doing punchdowns which I have always found to be a real pain.

Have made multiple purchases of these keystone couplers over time and have always found them to fit panels well, retain cables when connected, and provide good signal pass-through. As far as I am concerned, they're well suited to purpose.One benefit is that they're actually a bit stiff to insert in the panel cut-outs. That's a good thing, because I have dealt with other couplers in the past which do not fit as snugly, and that has sometimes meant that they are prone to popping loose. that is not the case with these VCE couplers. They stay firmly attached once inserted.

Very good quality, ul listed and the couplers are sized right to fit wall plates properly, would recommend them and would buy them again

Thes are great to use when you have wall outlets,and the cord already has the ends on them. These are just literally plug and play. These fit my keystone wall plates well.

Bought these to replace a defective one from another manufacturer that never properly seated in the wall plate - this VCE product clicked in firmly and withstands disconnecting and reconnecting without pushing in to the wall like the previous one did. I like these inline couplers as they can be used with premade cables without the need to use a punch down tool like is needed with bare CAT6.

Poor Fit. Broke one then bought Leviton which fit perfectly.

First of all, I bought these because Home Depot wanted to charge $5 for a single keystone RJ45 connector to put in the wall. I needed 4 to run two ethernet cables from downstairs to upstairs.I quickly searched for a RJ45 connector (ethernet) and found this, and bought it without realizing it's a Coupler. This has a female RJ45 on BOTH ends, requiring 2 male plugs to complete the circuit.I ended up using these, I just had to crimp four connectors in the cable in the wall, and then on the wall plate, I stuck the coupler in, and plugged the new wall plug from the inside. You will never know looking on the outside, and it works, so I can't really complain.With all that being said, I have had no issues since setting up the ethernet in my wall, these seem to work just fine, after about a month, and I saved $15 vs buying at home depot the proper parts.