2 Pack Corner Light, Plug in Overhead Light with Switch, Corner Lights for Living Room, Bedroom, Modern Wall Lamp, E26 Socket, (Bulb not Include)

This is a great space-saving lamp. I installed mine in the ceiling corner above a set of shelves displaying decorative statuettes. The light shines down perfectly illuminating my display. The lamp is light but sturdy, the two hanging tabs can be bent to align the light flush with any corner walls. Personally I have vaulted ceilings, so I found I needed to attach an extension cord to the light's power cord to reach the nearest wall socket. I think even with standard ceiling heights the power cord may be a bit short for reaching the sockets it needs to. The face plate is attached by screws, which when the light bulb needs to be changed must be unscrewed and rescrewed. Over the years stripping of the screws may become a concern, I wish the face plate snapped into place or had some kind of fastener designed for quick on and off engagement. The package came with all necessary hardware to install + extra pieces of hardware which were not needed but always nice to get. I added the unused hardware to my home tools and parts collection. All in all it's a great light, it does it's job, was very easy to install, and feels sturdy enough to last for years and years, it just seemed a bit pricey for as simple a product as it is. Other than wishing it was a bit less expensive, I'm very happy with the purchase.

This is a great concept for a light. It illuminated the room while being out of the way, and aesthetically looks very nice.Took off one star because of a design flaw. The instructions say to make sure the lightbulb is at least 2 inches from the wall for safety reasons. In order to be 2 inches from the wall, it is impossible to install the fixture flush with the ceiling. It leaves a barely noticeable gap when you enter the room, but it is disappointing nonetheless because the pictures show no gap.

I live in a very old apartment that doesn’t have many light fixtures. I had been using smart floor lamps primarily, however they take up some small, but valuable real estate and seem to frequently need to be re-connected to the smart home. This fixture is a really simple, elegant solution. I put in a high lumen smart bulb, and it takes up zero floor space. The single fixture with the high lumen bulb lights the 18 by 12 ft living room very effectively. I would suggest getting 2 for a room that large (I still have a floor lamp on the other side) but it’s been fantastic. It also has a manual switch on the cord if you don’t want to go the smart bulb route. Overall, this met a high expectation at a low cost. Also very easy to set up.

Absolutely love these in the small bedroom I installed them in (ended up getting a second one because the first one was so totally brill). But here's the key to "loving" them. First, make sure that when you are fitting it into the corner, that you firmly push it into each side wall with the "V" end firmly into the corner. The little screw brackets will bend to fit as you push in. Then mark where the screws will go with pencil, this is key to getting a good fit after you apply the self-adhesive foam strips. Next, when it comes to the self-adhesive light-blocking strips, apply them to the very edge of the two sides that go against the walls, (not the flat back of the fixture). Do this after you have first fit the light frame into the corner. Then, drill the holes for the screws, gently press the light frame with the foam strips attached, up into the corner (you may have to gently poke along the edges of the strips to make sure they are flush with the edge of the frame against each wall) then screw in the screws. I followed these steps for both lights and they both fit firmly into two corners with no light bleed around the edges. As to light bulbs; I purchased daylight led bulbs that are brighter than the bulbs the lights came with. Yes, it's extra money, but the finished product is a way better light spectrum than the yellow-y shade of original lights....just my personal preference here. The other thing I did for a finished look, and because the main plug-in I was using for the first light was one of those that is connected to the light switch to the room (no ceiling light in the room), I snipped off the original plug-in head and spliced in a trimmed extension cord with a 360 degree swivel head that I plugged into that receptacle that is tied to the light switch. And then I installed diminutive single cord covers over the entire line and it works perfectly....just in case someone else has the same room setup. All in all, I would do this again and may decide to if the next house I buy has the same light switch dilemma. I love that none of the floor or side table space is taken up by a lamp with enough light for the room, but mostly, I can walk in and flip the switch and the light comes on. Then if I need extra light, I can go to the other corner and use the existing toggle switch to turn the second light on. Can't say enough good stuff about these very affordable very functional lights.

Needed these to provide extra light in a bedroom, put a smart LED in them and they are great. Easy to install.

So not worth it. Minimum material and very difficult to install. The extra light was disappointing I would have sent it back put I recycled the box. My bad. Extremely overpriced

Cute but not bright enough

Not the greatest instructions, have to make sure to put that foam in the sides so that light doesn't seap through.