Caltric Carburetor Compatible with Honda ATC125 ATC-125 ATC125M ATC 125M 1984 1985

So far so good. Will give it time and update if it changes

After install on my 125m only had to adjust the idle. One thing to be aware of is replacing a carb from factory you need to have longer studs. I cut to head off some bolts and made my own as the factory carbs are threaded in the housing and these have a square nut in the outside which requires roughy 1/4” longer studs. If you do not do this the intake tube will not properly fit in the factory air cleaner box and can cause dirt injection. I like to keep my engines protected and one of those small cold air intake cones on the carb are a joke in my opinion if you are doing trails with mud/water etc. very satisfied will buy again

Perfect fit for 125M three wheeler. Price was perfect and fit like a glove!

This worked good for 3 years, then started leaking gas. I burned out the gas whenever it wasnt going to be used for 7 days and generally took care of this. My other motorcycles use new cheap carbs too, and those have never failed, even after 15+ years. These are cheap and mediocre quality. I'd gladly have paid $10 more for something more durable. I bought a second because there wasnt something better i could find.

Outstanding performance. Bought this for an 1984 Honda ATC 125M. The original Keihin carburetor was far beyond repair. Keep in mind, this is a knock off, however, it's a very good knock off. The only differences I could tell is that the slide on the original Keihin is metal while the slide on this one is a composite material (probably a considerable improvement actually). Also you'll need to retain your mounting studs from your old carburetor. Everything fit right were it was supposed to. Factory choke and throttle attached without issue. The little 3-wheeler started and ran better than it has in eons, much to my son's enjoyment. Ok....mine too...

Fits 1985 honda atc 125m three wheeler with horizontal engine

Removed studs from old carburetor. You don't have to buy new studs or bolts the old studs will screw out.Also used old cap on throttle because the new cable stay was a bit shorter. 3 wheeler starts and runs great this is an great value.

Used it on a Honda 125m three-wheeler. The original had studs coming out of it to bolt onto intake tube, this had nuts seated in a railing. Did not come with bolts and if it did I wouldn't be able to fit one side of the intake onto the carb because of a bend. So I just switched the nut to the other side after prying it out and was able to run bolts that way. That is the only issue I had. My bike runs better than ever with this carb.