YITAHOME Chimney Cap, 13" x 17" Chimney Cover for Outside, 304 Stainless Steel Fireplace Chimney Caps with Adjustable Metal Strips, Screws & Gloves

Well made with sturdy material and installed easily.

Assembly is straightforward, fit and finish is excellent.keep all the screws to the 4 side panels loose until you have it fit on the flue, I used a generous amount of adhesive on the flue and then simply installed then tightened the screws up and it's very secure on a standard 8x13 clay flue without the need to lag it into the chimney itself.

Good value and the correct size l needed. A bit flimsy but once it's secured you're all good. There's no way in hell Lowe's or Home Depot could've sold me this cap for only $75, if they even sold it, you'd be paying far north of $100. Here's a tip: take some epoxy like jb weld and epoxy the cap nuts on the underside of the cap. That way you can remove the cap while keeping your nuts. There's four Phillips head screws holding the cap in place and the aforementioned nuts on the underside of the cap. I also bought some fine mesh stainless steel sheets here on Amazon and wired them to the inside of all four sides to keep and critters out. Good luck and we'll see how she holds up over a few years.

Far more sturdy than I expected. Very easy to assemble.I was kind of worried when I ordered this because locally a S.S. chimney double vent was very expensive and others here on Amazon were around $300.Pro tip: get some tapcons and a proper drill bit, not some Habor Freight set, and this will install just fine. I used 4 tapcons and some exterior construction glue to secure it. I'm a little retentive so I ended up going back up on my horribly steep pitched roof and sealed the cap on with fibered roof tar.I would recommend this product.Too bad some of the sizes are a long wait to receive, luckily my size was in stock.

Comes in pieces that you will need to put together. Pretty easy though.

5 small bolts needed for assembly were missing. In came disassembled but had no assembly instructions

I was pleased with the quality of the metal and all of the stainless steel fasteners. The included directions had good diagrams that made assembling them not difficult. Brackets were included to affix it to the chimney. I did buy different hardware to use for the installation, as my chimney is clay/concrete and required masonry anchors and screws.

The assy is weak due to thin ss, but should do the job. However I took dimensions as nominal and picked length short of my tile size. So I must adapt the fit to my tile size. This means adding ss to secure the cap to the chimney. This was my fault. Generally this is a good product at a good price.