Nilight Tray Lights Push Button Switch 12V ON Off Switches with Connector Wire Kit 1.54" x 0.83" Replacement for Toyota FJ Cruiser Fortuner Ta coma Highlander Tundra 4Runner Prado Land Cruiser

Very good quality. Good fitment.

I have a 1st Gen Sequoia and apparently there's a common issue where every 12v power outlet with exception to the cig lighter stops working. I replaced fuses but nothing.Come to find out that others have the same issue and the culprit was Toyota's Intelligent Power Outlet board getting fried due to water damage.I was pretty much left with two choices: Replace the entire Fuse Box($$$$$$$) or Bypass the IPO relay. I did the latter by following the instructions provided by CarlosClasson on the Toyota Nation forum. IT WORKED!!! Buuuut now I had a feature/bug. I went from No Power Outlets to Always On power outlets. Which was cool but I wired a LED QC USB charger to the power outlets. So although minimal, could still drain my battery after a couple days.Enter this switch. Basically rather than having a jump wire give constant power to my outlets. This switch gives me manual control of my Always On Outlets and with the added benefit of being lit up when power is on but the car is off, I can't forget to turn the power off.It's a really sick mod and this switch really is the chef's kiss.

Little confusing but got got wired up to my led spotlights. Works as it should

Easy to install, worked perfect on my Toyota Tacoma.

I've gotten these for a Tacoma but in this case, it was for a 2008 Toyota sienna. It wasn't listed in the description but I took the chance and sure enough, fits like oe. Good quality switch and comes with the harness.

Spent a lot of time installing and wiring it up and it worked fine, for about five on/off switch cycles then it failed. It works if I hold the button in so the little latching mechanism inside is super flimsy. Super tiny wires. Absolute cheap junk.

Can’t wait for Amazon to deliver my Lasfit light bar so I can hook up my Zombie switch

easy to install and wire , will need to wrap with electrical tape , do not perfectly fit in older toyota slots and newer toyotas have all different tabs that will need to be filed flush