G&SG-S Hypo Cement, 1 Count (Pack of 1), Transparent

G S Hypo is just what the watch doctor ordered! Came quick & is specifically used for precision work. I used it to reattach my watches sapphire crystal. It was easy to use and my Swiss watch has its crystal back in place & holding tight. Great product.

Excellent product. Perfect bonding. Pinpoint accuracy. Dries crystal clear

I used this to fix a sapphire magnifier to an acrylic watch crystal. It worked very well. It goes on wet but not too too wet. I doesn’t act like water… I didn’t follow the instructions to a ‘t’ because I wanted the cyclops to set as clear as possible, and whether it was necessary for me to do so may remain a mystery. Still, it dried crystal clear and anyway I felt I needed as much work time as it would allow. The glue gives you about 5+ minutes of said time before it’s really set. Then I left it to dry overnight. However, an hour or two might have been sufficient. Suffice to say I was not ultimately pleased with my placement of the cyclops and a week later I took pains to remove it. 3 seconds of heat from a cheap solder gun on the lowest setting released the adhesive. Still, the heat was enough to create a large crack in the crystal. Acrylic will crack as heat dissipates from it (at a certain rate of speed)?? At first I thought I used too much heat but I really don’t think so. I think the crystal would have cracked non the less. For extra torture with this project I decided to replace the cyclops magnifier because I could use the practice and also, why not???!!! And just as you would have it, I somehow placed this thing perfectly. I mean it’s absolutely ‘factory’ perfect. So perfect in fact that I nearly threw up all over the watch. Just staring at the massive crack running underneath a perfectly placed magnifier. Well, good to know I can do it I guess… Now on to shop for a crystal press and await the joy of purchasing 20 crystals to find the one perfect fit. This is my week today.

Exactly as described. Works well for jewelry makers.

Great glue for repairing jewelry or adding tiny gems etc but I was looking for a glue to affix jewelry hardware such as earring studs and gluing a cabochon on a ring. Have had them both pop off many times. I was so excited about this glue but alas it didn’t work for what I needed it for. Now I use jewelry resin and mix together a little bit each time and it actually works! Not 100% of the time but it works!But as I said it’s great for repairing jewelry and gluing for example a concrete flower together but as far as gluing the hardware on, it’s not the greatest.

Works well for jewelry making. It does have a strong odor though. Nice fine tip but it's hard to get the twist off cover back on as you have to be precise due to the fine tip. However, we need that fine tip for jewelry, so can't complain. It works so I'm still giving it 5 stars.

The room stinks like spray paint the second you start using it, The glue POURS out of the package non stop, it gets everywhere, its impossible to put the tiny tiny needle cap into the tip when glue is constantly coming out. You waste SO MUCH glue it never stop slow coming out when the cap is off. The product stinks so bad and its thin as water. gets everywhere. travels on rings like water doesnt stay where its suppose to its been 2 hours they rings are dry the pearl still moves around. This is a nightmare of a product. Is this really what everyone uses. I am RUNNING back to aleene's glue. I didnt know how good I had it til I got this pure trash. BEWARE

Used first time today for a craft Worked perfect.