3D Printer Part m3 x 15mm PT100 Temperature Sensor A Thermocouple Sensor 1.4m Cable Compatible with UM2 Ultimaker 2 Ultimaker 2+ Extended+ 3D Printer

Replacing the failed sensor in my Ultimaker 2 with this one was easier than I expected. It has the right connector and the perfect length. Another review expressed concern about the temperature range. Since the Ultimaker's highest setting is well below 300°C, I'm not concerned.

Beim Upgrade vom UM2 auf Olsenblock ist mir wieder der Temperatursensor abgerissen... Dieser hier passt genau lässt sich gut verbauen, auch der Stecker Passt für den Ultimaker 2

Worked for a couple prints before it started giving me temp sensor errors. Even when the printer is stone cold after sitting overnight, I can see the nozzle temperature swinging wildly. I made sure it was properly plugged into the board and seated inside the heater block.The ability to buy this part quickly and cheaply is nice, but it is not worth the headache if you have to replace it this often. I suppose the old adage, "buy nice or buy twice" is true. I will be replacing this with a genuine Ultimaker part.

Bis jetzt habe ich noch keine Probleme gehabt. Mein 3D drucker läuft den ganzentag und hat mit diesem Thermostat kein Problem.Auf jedenfall empfehlenswert.

Had a hard time finding this part. Found this one and saw some negative reviews. Bought it to give it a try since cannot find one. Worked for a few prints then got the temp sensor error. So, if you can find one somewhere else do not buy this one. If you buy it be warned it may fail in short time. Buy at own risk...