One MissionXParacord Handle for Hydro Flask Wide Mouth Water Bottles - Fits 12oz to 64oz - Durable Strap Carrier, Carabiner, Secure Holder Accessories

Does what it says it will while being mindful of aesthetics.

Love these. They make sure I don’t drop and dent another hydroflask!

I have a Hydro Flask 40z wide mouth bottle (2.0 version—exposed bottle collar) and the strap makes it feel secure when I’m carrying it around. The only downside was trying to fit it onto the bottle. The ring was too tight and I had a hard time attaching it, until my partner was able to squeeze it on while using a lot of force. Other than that, it’s super adorable and I get complimented on it all the time.

All of the negative reviews are from those who didn’t put it on the bottle properly. I’ve been using this with my 64oz bottle with zero problems. It fits perfectly - to get it on, run it under warm water to loosen the plastic a bit, snap it onto the correct area, and enjoy! 5 stars for sure. It is so cute!

This product is top quality and durable! The disk that sits around the neck of the water bottle though is to thick and you can’t get a seal on the bottle. Your beverage comes right on out! Very disappointing!

Fits my iron flask 64oz

The media could not be loaded. If you use a straw lid, READ THIS!Firstly, I didn't realize this is hard plastic, not silicone. I don't need the carabiner, so the loop on the ring for the carabiner is useless and gets in the way.When using with a straw lid, the buckle and the sliding toggle also get in the way of opening the lid. Each time you need to undo the sliding toggle to be able to move the handle out of the way enough to get the lid off and on.Lastly the handle is very thick and wide. It's too big for my small hands. The flower pattern is very cute but the way it's woven makes it curve upward and didn't feel good in the hand. For these reasons I am returning.

I didn't have a hard time putting it on at all. Most reviews say to heat it up to make it easier to put on. Texas 100+ degree heat did that part for me so it was really easy to put on.

This handle is meant to attach to the top of the waterbottle and snap into place. It took 30 minutes for me to install the handle however now that it is installed it works as expected, it stays in place when the lid is off and does not interfere with the straw lid on the hydro flask.In order to get it attached I did have to soak it in boiling water for 1minute then attach it immediately once removed from the water.I am unable to speak to how easy it is to get off because I don’t want to remove it and go through the hassel of getting it back on. Once on it works fantastic and looks amazing

this is just a thin ring. it pops off the bottle immediately and doesn’t stay in place. the ring in the product photo as well as other people’s reviews is thicker and looks like it stays in place. mine is too tight to makes it all the way down, which causes both my straw lid and original lid on my 32oz wide mouth bottle leak. totally got ripped off.