2 Pairs Ball Lock Keg Post, Stainless Steel Homebrewing Beer Cornelius Corny Keg Quick Disconnect Kegerator Gas + Liquid 19/32-18 Thread Adapter Poppet Spring Sealing Gasket Replacement Kit

If you get this far, then you need this product.

This gives me confidence to buy used kegs again

I wanted to replace all the post from two new kegs I got just to make sure the fittings were all correct. When I received them I thought they were ok looking not as hearty as the ones I would be replacing but looked to be ok. I put them all on and made sure to also purchase a new ring kit for all the parts that used rubber ring, first one done past the co2 test and I am on my way, or so I thought, second one was put together like the first and co2 was added and started to leak badly I could not for the life of me figure it out, I sprayed, I listened, I did everything I could to find the source short of ripping the keg apart. I then trout to change the top, that wasn’t it, so now a few hours go by and I decide to put the old gas post on and you guessed it not a sound, or leak happened. So moral of the story is I had a poor functioning part from this company and I also realized that the make of the other 3 are not as precise as the original. That being said I don’t want to wait and have to tear down the kegs again to return them and possibly get the same results. Lesson learned

Turns out, the way you tell the difference between the gas nut, and the liquid, is the gas has a little barb/notch on the edges of the bolt. They are task specific hardware and need to be identifiably different, so there you have it. These work great! Perfect ball lock kegs now!

I ordered three sets of these to replace my old posts. They all leak badly! Seems like the nut is too long to properly seat on the kegs maybe and they bottom out? Or maybe just made to poor tolerances.

This ball lock quick disconnect corny keg post kit is great. I recently bought a used corny keg and the ball lock quick disconnects kept getting stuck on the keg posts, especially on the gas post. I removed both posts that came with the keg and replaced them with these. Now everything works perfectly! No gas or water leaks and now all my ball lock quick disconnects can be attached/removed easily and without an issue. The keg post installation was a breeze, all you need is a 17 mm combination wrench (an adjustable wrench or deep socket will also work). This kit comes with all the pieces needed to replace your corny keg posts, however when you are removing your old posts be careful because there is a spring and metal poppet in/under each post.I am very happy with these ball lock quick disconnect corny keg posts.Thank you for reading my review, I hope it was helpful!

As a homebrewer, I've got 5 ball lock corny kegs, with three on tap at all times. Over the years, it's normal to perform routine maintenance on these kegs, so having an extra set of keg posts is always good to keep on hand. These fit my kegs perfectly, and the manufacturer was nice enough to also provide an extra set of O-rings. This product is a good value, so if you need to replace your old keg posts or want to have an extra set on hand, I'd highly recommend these.

I used these for used kegs I purchased that didn't have posts. Right away there seemed to be a problem. I thought it might be the kegs, but I tried posts I already owned and they worked fine. I tried these new ones on kegs I know are fine, and there still seem to be an issue.And now I think I mixed a couple of these new ones in with my old stock accidentally.