EXZEIT 160W 5 Inch Driving Lights,11200 Lumens Fog Lights Offroad Lights for Jeep Wrangler Trucks Toyota Pickup SUV ATV,12V/24V

These are very well made and come with all common hardware needed for most installs. The construction is cast aluminum and very sturdy. There are two sets of lens covers, clear and amber, which is only parts I question how long they will last. This comes with both pigtail wires if you are replacing lights already wired or a full wire harness for new installation. The harness has leads to hook up to battery with fuse in fuse holder and relay, the light end has sealed plugs to plug into lights. The switch has double stick tape on to to mount easy and has a separate power wire so it can be hooked up to live power or ignition power depending on preference. The red LED will light when powered and off and the green LED will light when lights on. I had enough wire to mount on brush guard of my XRT 1550SE, run switch to dash and power leads to battery under back seat, but just barely. Most UTVs should have plenty of wire. Other vehicles could have problem if power source is too far from switch location. Right now I have amber lenses on and I am very happy with brightness. And they shine very far ahead of UTV. I am extremely happy with these lights

These are stupid bright definitely buy if you are looking for really good lights

OMG are they bright. I would not recommend using on the road unless very foggy or extreme bad weather. These are liek daylight even with the amber caps on. Nonetheless, I'm very happy with the product.

Product quality looks good and solid,

They look great and I purchased another set for my wife’s Jeep JK. Comes with diffuser lenses as an alternative.The Negatives:The lens cover isn’t sealed so water can and does get behind it. No instructions were included in either of the units I purchased as to how to change the lenses. The power leads that came with the units are very short and splices had to be made outside of concealment… luckily I was able to get them inside a wire loom.The leads could Stand to be 4x longer.

Easy to instal . improvements would be put small plug connector on harness to pass through fire wall of vehicle so you don't have to bore a large hole in vehicle . also had a problem with one of the large stainless bolts that mount bracket to bumper ,right before it got tight it jammed would not tighten or loosen. I had to grind bolt out. use different bolts.

These are very bright and works great, they were easy to install. I just replaced my old school existing lights so I can see on the night runs. Definatly recommend if you are not into flashy name brands and just need to see at night.

Easy Install, Very Very Bright, When They Were Working... LOL.. Went To Turn Them On This Morning And They Flickered And Then Went Completely Out.. I've Checked Everything, And Couldn't Find A Problem.Then After Further Investigation I Found I Used To Small Of A Gage In Wiring.. Be Sure To Use Wiring Equivalent To The Same Gage Or Bigger As They Will Melt It And Could Cause A Fire.. Luckily It Only Melted On Mine..