Blowout Sale Suppressor Cover 6 inch Black fits silencerco Silencer

My suppressor with a QD mount is 6.8" and my first cover I ordered was for a 7" suppressor.The 6" cover is a much better fit. It covers the suppressor without excess material.

I bought this cover a while ago and finally had a chance to use it. After 60, yes 60 rounds of 556 the top of the cover was shredded, even though the pictures on the amazon page showed a front vented suppressor!!Also, around where the front of the cover was shredded the inside material was smoking/smoldering.. On top of the cover being shredded the base of the Velcro melted and the para cord was stuck in it, keep in mind this was after 60 rounds. I DO NOT recommend this cover.

Product works better than most I’ve seen on the market. It could use a video link on a card or instructions on how to tie the 550 cord. Additionally, I found that if you don’t use the 550 cord to cover the metal plates you will get burned by them if held for a couple seconds after shooting a few rounds down it.

Can't brag about it. It's on my compressor now half burnt off. Lasted one trip

Specifically for Omaga 30cal but It’s a tad too small

After 20 rounds through a bolt gun on a Silencer Shop Sythe Ti suppressor. It literally melted Velcro straps off. You decide but I wouldn’t give it even one star.

This product is the canvas cover that goes over the heat resistant portion of the suppressor cover. It does not contain the actual insulating material.

I like the design, perfect fits for my Omega 300. It came loose after a few shots and the barrel got hot.