Fuel Tank Sender Stand Pipe Pick Up Inline Fuel Filter Hose Clip Pipe Line Kit For Webasto Eberspacher Diesel Heater

Use on Chinese diesel heaters with 5 gallon cans. Works great. Get about 5 days from a 5 gallon cans now. Much easier than the tiny tanks that come with them normally.

Used this for tapping a diesel container using the cap (with an air hole) for a high capacity external tank for my diesel heater, works perfectly. The steel tube is hard to cut down but thats a good thing. Filter works, perfect amount of connecting rubber hoses and clips for connecting everything with one set to spare! Great fuel hose with plenty of length to spare. FYI you have to tap the hoses to help the priming process but once it starts u are good to go for refills. Not quite a quick connect/disconnect but just a few turns and ur good to go!

Used to modify a plastic 5 gallon diesel fuel jug for my diesel heater in the garage. I have two fuel jugs that are rotated as needed. They sit on a shelf. I had a spare solid cap without a spout and drilled a hole through it to fit the metal piece. Then ran the fuel line to my diesel heater with the filter inline. The drop tube was bent slightly at the end to fit into the jug and the cap is screwed on loosely to let air inside the jug to prevent a vacuum. The modified cap and drop tube is switched between the two jugs as needed. I’m good for about a week of continuous heating on one jug and have run this over the Winter season without any problems. This solution works well for my stationary setup.

I used this to tap into the diesel tank of my Skoolie for my Chinese diesel heater.Works just like it should and haven't had any issues thus far.I would recommend using JB Weld SteelStik epoxy if you're planning on putting it into a fuel tank where you can't get the backing nut on to create a strong seal.The clamps are solid as well but the screws are metric so unless you have metric nut drivers you're stuck tightening them with a flat blade.

Added to vevor diesel heater and works great. Added connection to a 5 gal gas can. Make sure to get all connections real tight!

Just a very good upgrade for my diesel heater I highly recommend it. Came very fast in mail.

I got two of these to install two diesel heaters in my bus. They work perfect. I drilled into the diesel tank, threaded the hole with a tap, and screwed this in. They work perfect, and I’ve had no issues.

The listing didn't show how the black sleeves were to be used so at first I thought the fuel line was too small.After examining a few minutes I realized the sleeves with the clamps are unions/couplers and the fuel line goes inside them.Purchased to eliminate air getting in the line and it seems to have done the job.