INTEX 68624EP Motor Mount Kit: Easy to Attach – Heavy-duty Composite Mount – Marine Plywood – Aluminum Support Arms – Fits up to 3.0 HP Motors

We used this on the Intex excursion 5. It worked really well and supported the trolling motor. It was easy to assemble and install on the raft. I would reccomend installing on the raft before inflating it.

Looks sturdy very easy to put together its almost fool proof, didnt even need the directions just look at the picture on the box.

We have the Excursion 4 by Intex so when we wanted a motor mount we of course went back to Intex.It is the only name we trust and have several kayaks as well.This was easy to put on the boat and came off just as easy.The price is great as we saw some that were not specifically made for this boat at much higher prices.Great buy.

I tried this out with a Minn Kota 30lb thrust motor a few weeks ago on my Intex Excursion 5. It works, but the poles seem like they are just a tad short, and the two setting areas only offer around a inch difference in length. The back plate came loose, but that was after 5 hours of play and 45 min of max speed, and I didn't torque the nuts down very tight.It fit but was a bit of a pain to attach, on the instructions it says to wait untill fulling inflated but it was easier to hook it on halfway through inflating.Overall a good, fair priced mount, I'm just really picky

Product came as described and fit right on my inflatable boat I can’t wait for this water to thaw out

Used this for a 36lbs minnkota trolling motor. It was easy to install although the instructions are a little confusing. It took about 30 minutes to assemble and attach. The other drawback is that when the motor is on max power the mount tends to not sit straight. Otherwise I had no issue with it and it’s pretty stable.

Exactly as it says

what I needed